My washing machine keeps giving me a error 20 code and dosent finish the cycle

Here are a few general troubleshooting steps you can try:

1. Check the water supply: Ensure that the water supply to the washing machine is turned on and that the water inlet hose is not kinked or blocked. If there is low water pressure, it may affect the washing machine's operation.

2. Clean the filter: Check if there is a filter in your washing machine and clean it if necessary. A clogged filter can cause issues with the machine's performance.

3. Check for any error codes: If your washing machine has a digital display, check if there are any error codes being displayed. Refer to the user manual for information on what the error codes mean and how to resolve them.

4. Reset the machine: Turn off the washing machine and unplug it from the power source. Wait for a few minutes, then plug it back in and turn it on again. This can help reset any temporary glitches.

5. Run a test cycle: Some washing machines have a test cycle option in their settings. Running a test cycle can help identify any specific issues with the machine's functionality.

If none of these steps resolve the issue, it might be best to contact Daiwoo customer support or consult a professional technician for further assistance. They will be able to provide specific troubleshooting guidance for your model of washing machine.

OE error code indicates that the washer is unable to drain the water it used during the wash cycle. OE can be triggered by a kinked drain hose or a clogged drain pump filter..... please clean drain hose back side of washing machine.. Thank you

Have you cleaned your machine lately? They make an in wash boost- it gets rid of the extra suds built up inside the machine that you cant see but your machine detects it and causes faults such as that. Also, there is a small wire on the control board that may need replaced if it keeps kicking the error code.

This video will help you diagnose the fault on 3e error codes and the video will help you solve the problem

Are you getting an error code? If not, Try unplugging it for 20 minutes.
Then plug it back in, The ccu might have to be reset.

if there a advance cycle button push it an see if the timer will advance to spin if not turn the power off to washer an wait a couple mintue an the door will open

The code is UE

load too small.
• Load is out of balance.
• The washer has an imbalance
detection and correction
system. If individual heavy
articles are loaded (bath
mat, bath robe, etc.) and the
imbalance is too great, the
washer will make several
attempts to restart the spin
cycle. If an imbalance is still
detected, the washer will stop
and the error code will be
displayed.
• Add 1 or 2 similar items to help balance the load.
• Rearrange items to help balance the load.


please rate this help to keep the service online

After reading what others said on how to fix, I followed their suggestion of the coin trap, bingo, it was my problem as well. Thanks great help!

if your water is to cold it will have the same error. Somtimes the water from your water heater is not warm enough so you have to run the water from another source till it is coming out hot. this solved my problem every time.

im having the problem now with my daewoo that every time i put a wash on its giving me a H6 message error