Ods10 levaton I ought a 2 pack of levaton ODS10 occupancy switch. Tried to install one could not get it to work I installed according to iTube video for this switch hot wire to black, green to ground white wire to the blue wire. I could not get the led light to flash on the switch. My lights blink on for 30.seconds then turn off.then on then off continuously. No matter where I have the settings. So I tried the second switch no flashing leds on the switch. Lights stay on all the time cannot turn off.What am I doing I have confirmed my black wire is the hot wire.could I have 2 bad switches? I have 2 wires in the box W/A ground black hot wire &A white neutral wire , ive wired black to black, Blue to white and then ground to ground. What am I missing?

SOURCE: wiring ceiling fans to wall switch

Hi Bigelow,

You need two switches.  It sounds like the Electrician set up the junction box for two circuits(Lights and Fans).  i say this because your supply has 4 wires, Red , Black, White and Bare. We may be able to oversome this with one Lutron Switch. Allow me to investigate, and I will be back.

SOURCE: Wiring for Bosch Hologen Fog Lights? Wiring

Look on the relay for the terminal numbers.
Terminal 30 goes to the battery positive.Red Wire
The two terminal 87 go to the fog lights.Black Wires
Match the color wire with what you have on the relay connection for the rest of the wires.
Terminal 86 should connect to your low beam headlight.
Terminal 85 should go to the fog light switch.
The fog light switch should connect to the terminal 85 and the other terminal on the switch will connect to ground.

SOURCE: I'm using a Leviton 1755 combo 3 switch for a bath

remove white switch one and connect to incoming white ground--all whites should be connected [hooked] together these are grounds-- switch 1 black from fan ,leave switch 2 red from fan ,switch 3 vanity black

SOURCE: Replacing a pull chain 3-way ceiling fan light switch

OK .. the thick black and white are the power for the fan , are there also white wires on the lamp sockets ..??
The thick black wire should connect to the black wire on the switch.
The small black wires connect to the red and blue wire on the switch .. two small black wires each .. that should give you a position for 2 lights , and 4 lights, on the step switch .. but there should be white wires from the lamp sockets connected to the thick white from the fan .

please respond .

Please Vote !!

Testimonial: "I appreciate the response, which reinforced my thought process and it worked - Thanks!"

SOURCE: Help with Woods 59018/59028 7 day digital timer

The usual connection for this type timer is the house black power to the timer black, the house white power to the timer white and the , the light black wire to the red timer wire.
If you only have two wires, one black and one white, at the switch location, then you cannot use this style timer , as it needs a neutral. You should return this timer and get one that does not require a neutral connection.

Please Vote !!