You don't, rep;ace the piezoelectric ignitor, it is the ignitor push button. Look online for a new one.
SOURCE: Igniter problem
right in front where the red botton pushs in to light! grab the ring around that and un screw it!
SOURCE: instructions on how to put a brinkman gas grill
It might be best to just contact Brinkmann's Customer Service Department first. They should be able to either send you a Manual with snail mail OR point you to a link where you can download a copy of the instructions needed. Good Luck!
* The Brinkmann Corporation
Attn: Customer Service
4215 McEwen Road
Dallas, TX 75244
Toll Free:
(800) 468-5252
Local:
(972) 716-4262
OR you may send them an email through this link:
http://brinkmann.net/Customer%20Service/ContactUs.aspx
SOURCE: new brinkman gas grill---side burner lights on
I have a few ideas that might help.
1). Before going to the expanse of new parts, your igniter AA battery MAY need replacing.
2). Your igniter wires might be loose. Remove the battery and check junction box found behind the Control Panel and connect any loose wires.
3). Check that the end of each of your main burner tubes are properly located over the gas valve fitting.
4). There MAY be an obstruction over the main tubes not allowing the gas lines to access it properly.
5). If obstructions in the hose or regulatory assembly is suspected, it would be best to contact Brinkmann directly at 800-527-0717
SOURCE: brinkman grill 3 burner pro series 8300 won't
To restore gas to the burners, follow the instructions below.
1. Turn the gas tank valve OFF and disconnect the hose from the tank.
2. Wait 5 minutes and reconnect the hose to the tank.
3. Open the tank valve VERY, VERY SLOWLY (Slow motion, slow).
4. Once the tank valve is fully open, light the burner farthest from the tank first and set the burner
control knob on HIGH. Does the flame height look correct for being set on HIGH? If so, light
the remaining burners the same way. Do all the burner flames look correct? If so, you solved
the problem. Remember, to always open the tank valve Very, Very Slowly.
If that didn't solve the problem, you will need to replace the grill's
Hose/Regulator Assembly. It runs about $30.00 at any home center or
hardware store that sells grills & accessories. If you replace it,
turn the tank valve ON Very, Very Slowly.
Hope this helped you to troubleshoot and solve the problem. Happy Grilling.
332 views
Usually answered in minutes!
×