Frigidaire model ftf2140fs0, fills, washes, drains, spins then fills for rinse then nothing then all lights flash with single beep. put in spin only then it will drain and spin.

SOURCE: LTF2140E Front loader washer

My Frigidaire front loader washer model LTF2140E doesnt want to drain the water when set to wash (heavy-normal-quick selectors). It washes put thats it. I have to switch the selector to drain/spin then rinse/spin cycle to finish the load. I checked the drain hose for any clogs....everything is clear. Any suggestions? Also,iIs their any reset buttons for this type of washer?

SOURCE: Frigidaire Washer/dryer combo

Dtronics,

A part called a (wig-wag) its a part that consists of two selonoids, one is bad. It switches the transmission from the wash cycle to the spin cycle,at the same time it opens the pump for draining.

hope this is helpful

handiman518

SOURCE: Frigidaire front loader washing machine won't spin...

just had my frigidaire fronter loader repaired,,try the door switch ...mines wouldnt spin clothes were soaked did everything else fine... what may have happen is when the spin cycle is ready to do its part it double checks to see if door is locked but with a bad switch it sends the wrong signal and computer this the door is open so it shuts off....well gl mines is running got lots of laundry to do,.,,,hope this helps

SOURCE: washing machine won't spin and drain

the drain pump is not working,after wash cycle the washer should drain the used water,if it does not function-all the next cycle will not commence.

SOURCE: Frigidaire front loader washing machine won't spin...

The problem is a faulty Door Latch Assembly. The same thing happened to my Frigidaire front load washer. The part is easy to install, costs about 60 dollars and can be picked up at most appliance repair stores . To access the switch just remove the wire around the front drum gasket, peel back the rubber gasket beside the switch assembly then remove the two screws holding it in place. remove the three wire connector blocks and swap in the new switch. My washer was giving me error code 41 witch is a faulty control board. But the problem was in fact only the switch...