SOURCE: Kenmore Master Flame Grill
Hello,
Burner will not light:
Here is a couple things you can check:
1. Gas injector not insert in venturi tube.
2. Clogged gas injector
3. Obstruction in gas line.
4.Spider webs in venturi tubes.
5. Misalignment Of collector box and burner.
6.Dead Battery.
7.Check hose to make sure it is not kinked
8.Check Hose to make sure it wasn't chewed by squirrles
9. If it is LP gas, Could be out of gas.
Other Issues:
Could be the way the grill was turned on and off, that also can be an issues. In your manual it will tell you how to do it proper, this could make it not light or have a low flame. If there is not hing in your manual, I will be happy to assist you.
Fireplace-Girl
SOURCE: overriding parental block code
If you forgot your password for this feature, press the following
buttons on the remote, one at a time. (Note: You must be in the
password entry screen) Press, Mute, Display,Clear and Reset, this
unlocks parental controls and you can now re-enter a new password.
OR TRY THIS..
Press
and hold Menu on the TV AND volume down on the remote for 3 seconds.
Nothing will appear on the screen, and the Parental Controls will
unlock, and you can re-enter a new password with the LOCK PARENTAL
CONTROLS
SOURCE: GE simon 3 security system How to reset master code?
The default master access code is 1-2-3-4, try it to see if this works.
SOURCE: Master Remote Control codes
I have a strand 3 in 1 you just need to press and hold shift/setup until the light stays on. Then press channel up. DO NOT press the on/off button but just let it cycle until the tv turns off. THEN press the ok button immediately.
SOURCE: HOW TO CONTACT PHONE WIRERS TO A ADEMCO WIRELESS
Go to your favorite search engine, Google or whatever, and use the phrase "Ademco Lynx Installation Manual". It has the instructions you need. You may have to look through 5 or 6 hits, but you can download the manual for free.
And please stop shouting. ;-)
262 views
Usually answered in minutes!
×