Konica minolta bizhub 164 have a service code c2558

Its a black unit error code
It means the black toner is not supplying to d developer you can reset error code by logging in d service mode

Minolta bizhub 164 error code C2558 how can solve

When was the last time the developer was replaced in the developer unit? If has been replaced then you might have a bad ATDC (Automatic Toner Density Control) sensor Located right below the developer unit (Same unit houses the drum. If the developer was replaced when it was done was a vacuum cleaner used? IF so the static electricity from the vacuum clear could have destroyed the sensor, NEVER USE a VACUUM cleaner to remove the developer. Also when the developer was replaced, was the counter cleared to tell the copier developer was replaced, the copier uses certain counters to determine certain voltages for certain assemblies, if not image problems and codes can appear. Finally was the F8 run after the developer was installed before any prints or copies were made? If not buy new developer and start over, counter is to be cleared first, then developer replaced, then F8 (TCR ADJ) run.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Replace the developer in order to get rid of this problem!

help me my konico minolta bizhub 184/164 error (C2558) my mail id [email protected]

I recommend that you will post your question under the correct category (Printers) it will be easier for Experts to understand the question and answer it.

machine trouble sevice call [c2558] wat a problam in konica minolta bizhub 164 printer

help me my konico minolta bizhub 184/164 error (C2558)
my mail id - [email protected]

code no 2558

tis error means abnormal tonder density in the balck image unit take the blacke image unit out and shake it while holding it level and put it back in the machine to reset the error code leave the machine on and open then close the front door