Clean washer button for Frigidaire affinity FAFS4073NWO won't work

Question edited for clarity.
Question moved to Affinity.

Try a full system reset. If that doesn't work, you need a service call.

Resetting the Frigidaire Affinity washer

• Unplug the power source or turn the circuit breaker off for a few seconds.
• Then plug the power back on to reset the washer to default settings.
• Now press the cancel button to cancel all commands.
• And in the next step press and hold the spin speed and soil level buttons together for four to eight seconds.
• Hold the buttons until you hear some signal sounds and then leave the buttons.
• After that open the door for more than 2 times and make sure it gets closed again each time. After this, your machine has been properly restored to proper default settings. This will lead your machine to work properly again.

..

Hello Larry Occhipinti, thank you for your post!

If you are pushing the necessary buttons on your Frigidaire washer to perform a system clean and they are not working, it could be a possible issue within the control panel. I would recommend a reset on your appliance which can be done by disconnecting power from your appliance for roughly ten minutes. If that does not correct the issue, you can run a hot water wash cycle with a cup of bleach inside the tub to clean your appliance out as well. I hope this is helpful. -Matt

Hello Jodi, thank you for your post!

Your Frigidaire washer (FAFS4474LW0) will automatically prompt you to run the CLEAN WASHER cycle typically every 50 cycles. If you wish to begin the cycle, press SELECT when prompted. This maintenance cycle uses hot water and two rinses to remove residue that may cause odor. For best results, I recommend to use the CLEAN WASHER cycle once a month

You may press the CANCEL button to manually perform the cycle at another time if you prefer. You can do this by following these directions:

·Rotate cycle knob to Rinse & Spin
·Then press the CLEAN WASHER option button
·The LCD screen will display "SYSTEM CLEAN"

Hope this helps! - Z

Shut off water and remove hose.

If the unit is washing properly, as far as you can tell, but it won't stop spinning, then I would have a professional look at the control panel and timer to be diagnosed because there seems to be in miscommunication.

I have no E90 code in my literature. You might want to check with Frigidaire.

Try "Jeans" instead of "Spin".

Hi,
Here is a tip about how to clean your washer

How to have a Clean Washer

heatman101





/,./,.

I was doing a search for infor on how to clean my affinity front load washer, and came across this infor and this did not work for me either, but when I turned my dial to rinse and spin then hit clean the clean option appeared.

Try holding the 'options' & 'select' buttons together till the door lock button comes on. This is the child lock function. You can do it again for the lock to come off. Hold down for over 3 seconds

Please reply or rate.