Aeg lavamat 509n pilot light goes on intermittently. If the light isn't on the machine doesn't operate

SOURCE: AEG Lavamat 1000

hi

dont know if this is the one you need AEG 1000 Washing Machine
you may need to scrool down to download the manual .


riz.

SOURCE: aeg washing machine fault code

This error code means your water sensor has detected a leak. it will stop when the sensor is dry.
Try getting the water out of the trap door and letting the machine dry.

I would also unplug it for secirity reasons.

Basically your water pump is getting tired or the sensor is dirty. Try cleaning the sensor or else you may have to change the pump.

SOURCE: AEG Lavamat 86720 washing machine

Hello,
This means your water sensor has detected a leak. it will stop when the sensor is dry.
Try getting the water out of the trap door and letting the machine dry.

I would also unplug it for secirity reasons.

Basically your water pump is getting tired or the sensor is dirty. Try cleaning the sensor or else you may have to change the pump.

post further comment for more help......

SOURCE: how do i reset a aeg oko lavamat 72620 washing

how to make reset to AEG OKO lavamat 61600

SOURCE: AEG Washing machine Oko Lavamat

Hi,

The C9 on some AEG LAVAMAT models like the 71400, 72600,74620, 86720 and possibly others, is the same as the above F9, and is usually MOTOR BRUSHES WORN OUT. After replacement, you will need to clear the fault indication held in the PROGRAMMER PCB logic: With the Switch in the OFF position - Press and hold PRE-WASH and SOAKING buttons in at the same time, then turn the control knob to Short Spin. Wait one or two seconds and all the indicators should illuminate. Then turn the control knob to OFF. All the indicators should go out. Then try and use your machine as normal. This should clear the C9 error code. If it does not -check there may be another fault present.

Please get back to us if you have further query else please accept the suggestion.
Thank you for contacting fixya.com