CONTROL BOX ON A BUCKET LIFT. - Refrigerators

I would try putting lift hose on the down side and down hose on the lift side. If it lifts when you push the down control and does not go down when you use the lift control then it may be a spool problem. Always take care to control all forms of energy when removing hoses to prevent harm or *****. I'm not sure if the spool on your loader is pilot controlled or mechanical linkage?? If it is mechanical take a look at all linkage and make sure its moving correctly. If its. Pilot control then the issue may be there also. Good luck and be safe.

You are describing an oil leak in the control valve. Get this to a hydraulic repair shop.

I am not familiar with the model but most hydraulics work in a similar way. First there has to be enough clean oil of the correct grade being supplied to the pump and then the pump has to produce enough pressure to make the system work and there is no point worrying about the other stuff until it has been established there is enough pressure, which could be anything from 500 psi to 5000 psi depending on the specification...

put the bucket on the ground and the tilt in a neutral position so that there is no load on the cylinder pins
turn off the engine
remove the hoses and cylinder pins
lift out
use plugs to control dirt from getting into the hose ends

got to be low fluid level only thing could be

If memory serve's it's a whole new control lever.

Check control cable from lever to valve to see if it has broken or seized

Sounds like a hose is being pinched when the bucket is down. Good luck!

Brand new out of the box and the bucket didnt fit flush and the shampoo or water not spraying?
Mine was the same lift up the bucket and look at the rubber washer / seal take it off turn it inside out and put it back on.
Wahoo the busket fits the was washes , you have your carpet cleaner back