My vrt samsung washer has a 4E error code - Samsung Washing Machines

SOURCE: Samsung VRT washing machine

nF means that washer tried to fill but was unsuccessful. Water supply valves needs to be fully open. Lines may be kinked or screen by the hose hookup at the washer end may be restricting flow. Check to ensure the screens are cleaned by removing hose and pull screens and clean them then try the washer again

SOURCE: Samsung Washing machine fault

Had the same problem - I posted full description in another 4E post - But my problem was a crack.split in the pipe to the sensor

SOURCE: Samsung B1245 front loader

When error message 4E is displayed, you should clean the water hose mesh filter. To do this:

1. Turn off the water source to the washing machine.
2. Unscrew the hose from the back of the washing machine.
3. With a pair of pliers, gently pull out the mesh filter from the end of the hose and rinse it under water until clean. Also clean the inside and outside of the threaded connector.
4. Push the filter back into place.
5. Screw the hose back onto the washing machine.
6. Turn on the faucet and make sure the connections are watertight.


Also, please check the following:
• Make sure the source water faucet is turned on.
• Check the water pressure.

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question!!!!!

SOURCE: 4E error....samsung J845

When error message 4E is displayed, you should clean the water hose mesh filter. To do this:

1. Turn off the water source to the washing machine.
2. Unscrew the hose from the back of the washing machine.
3. With a pair of pliers, gently pull out the mesh filter from the end of the hose and rinse it under water until clean. Also clean the inside and outside of the threaded connector.
4. Push the filter back into place.
5. Screw the hose back onto the washing machine.
6. Turn on the faucet and make sure the connections are watertight.


Also, please check the following:
• Make sure the source water faucet is turned on.
• Check the water pressure.

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question!!!!!

SOURCE: Samsung VRT Steam FabriC Softener not dispensing

My fabric softener intermiitently was left with clear water in the tray. The serviceman replaced the tray which did not fix the problem, he then replaced the valve assembly. That fixed the problem for about a year and now I am experiencing the same problem. Being the unit is now out of warranty, I purchased a valve assembly and replaced it but what I found in the process was that the real problem was that after removing the filter screen where the hose connects I found a SECOND mesh filter that was plugged up. I removed it with a needle from the edge so I didnt damage the screen. I think you could also just used a spray bottle with some water and a Q tip to clean. I wasted $50 on a valve assembly, but I did discover this second filter screen that is not mentioned in the user manual. Hope this helps someone because I have not seen this solution posted anywhere.