Old model glue that used to melt the plastic together isnt avail now what can i do
Use either clear epoxy glue on the back side or clear gorilla glue. Hold front side together/ in place until it fully drys
If you are able to access the backside of the tear clean the area very well soap & or digreaser
when dry wipe with rubbing alcohol & let dry. Then use either epoxy or crazy glue to cover the torn area & one or two inches beyond, as soon as you apply this glue, take some nylon webbing & lay it on top of the glue pressing down firmly. Once you have done that, apply more glue or epoxy over the webbing & cover liberally with baking soda, repeat if desired. Let dry for 24 hrs & patch will be hard as a rock!! Good luck.
×
SOURCE: Graco Metrosport stroller Model No 611198E
contact these guys for replacement parts; http://www.gracobaby.com/store/order/default.asp?N=10418+10413+10421&Ne=11 Hope this helps :)
SOURCE: harman kardon soundsticks II
use a clear silicone based sealant (similar to the type used for caulking and in fish tanks) I'm guessing you used CA or superglue, and thats what melted your plastic, you're using too much also most likely.
SOURCE: amana side-by-side fridge freezer only cold at the bottom
yes the evap fan in the frezer should be running when the compressor is running[it may not for a minute or so as it starts up.Amana's are good for the connectors at the evap fan motor comming apart.the connectors are white and will look like its together but when you pull it will come apart.i would always cut the connector out and use a wire nut so wont happen again.if any other questions please email thru FixYa and i will be glad to help. God bless ,tom
SOURCE: Braun multipractic food processor model 4259..
The disc carrier you're looking for is Part No 7002058 (the number may be stamped somewhere on the holder itself). It's like a circular/figure 8 kinda looking thing on a shaft. If you're in Australia I'll be able to help get spares.
Don't recommend using glue to repair due to stress breaking it again, and for food safety issues.
SOURCE: I am having difficulty glueing PVC together. I
3M Hot Melt 3764 is the correct adhesive for PVC.
253 views
Usually answered in minutes!
×