How can I get the back off my ice Master watch #1349

Waterproof or water resistant watches usually need a wrench to unscrew the back. I use a pair of 90 degree circlip pliers. A jeweller would remove the strap and fit the watch into a holder before using the wrench.

Few jewellers would guarantee the water resistance of a watch after fitting a new battery. If it is required a watch be returned to its original specification it must be returned to the manufacturer or an agent for battery fitting and pressure testing.

Some watches have a back that is pressed into place. Fairly easy to prise off but very difficult to replace without the tools. This type does not have the grooves a wrench fits into.

how to video

That is the master clamper area. Take off the rear cover. From the rear it is on the right. There is a motor and a rack gear that moves to open the drum master clamper when removing and loading a master. With the back cover removed, try to make a master while watching that assembly. You can also put the drum in and drive the motor by hand to watch and see if opens the drum clamper.

what company is it? MY NUMBER IS 1-352-419-1349

Hello,
you can open your ice watch most likely with a sharpen knife, but be carefull.



AED ARS AUD BRL CAD CNY DKK EUR MXN NZD NOK COP GBP RUB CHF USD JPYMy...

11347 1349 1143
1157 1172 1208
1360 1024 1115
347 1349 1143
1157 1172 1208
1360 1024 1115
These are the codes to check with Sany brand TVs. If you wish to get more, check these sites. http://remotesearch.blogspot.com/
http://electrohelponline.blogspot.com/
Pull up previous posts by its left sidebar, or type in the brand name and model number to of your set, to its search box, and press 'Enter' or view it in Mosaic / Timeslide option.

yes check the drain, it is located in the freezer under the evaporator at the bottom you may hae to remove the back panel to get to it...hot hot water is the trick to remove the clog..just make sure you clear all the ice and water away or it will freeze again..

If it overfills and drips, look for an adjustment behind the plastic endcover with a +/- on it. - is less water.

If it continuously drips, replace the water inlet valve on the back where the house water supply comes in.

Watch it when it fills with water. The fill tube could also be stopped up with ice. The water inlet valve on the back of unit opens when the ice maker needs water. If the valve doesn't seal good because of sediment or wear it will continue to drip and when the water reaches the ice maker supply tube it will freeze. You can take the water line off the valve and watch to see if it drips.

you simply pull out the crown then push the button at 2 o'clock as many times as needed to return the hand to 12.