My philips tv 37" turns on then makes a pop sound andshuts off after a few seconds

SOURCE: tv. does not turn on sometimes? philips 63pf9631d/37

The TV is in some kind of protection mode, the blinking LED show you an error code.
Try pressing 062596 and then press menu button (do these in quick motion, don't let them to time out while keying)...see what happens
Well I think that if you would have a service manual for this set that would help a lot, I can send it to anyone who wants it via email/gmail. Let me know if anyone want one.

I also heard that this problem appeared with some people because the of the burnt fuse in the TV. To fix that it has to be taken to the tech shop.

And yes I also heard about this issue many times, seems like this TV set is very popular with this kind of problem.

SOURCE: Turn on power, but no picture, when you turn off power see picture for a few seconds before tv shuts off

Even, I have the same problem...looking for a help on internet but not finding any...if you know...please post on this site.

Thanks,

SOURCE: 42'' lcd turns on no picture/menu

Your tv is being attacked by electrical surges which seem very violent and has already damaged some logic controls. Please invest in a AC filter which will protect your tv from such spikes....... but first you need to get your tv serviced from the electrical damaged it has already suffered.

SOURCE: 42PFL5332D/37 does not turn on red light flashes 6 times.

Don't have a "solution" yet, but found this table that decodes the blinks:

Error Code Table


0 = No error
1 = X-ray protection, E/W protection, and/or Vertical protection active
2 = High beam current protection active
3 = Reserved
4 = +5V protection active
5 = Signal Processor (IC 7150) register corrupted
6 = Signal Processor (IC 7150) error
7 = Total failure
8 = Internal RAM error (Microprocessor IC 7000)
10 = NV memory (IC7088) addressing error
11 = NV memory (IC7088) size error
12 = Histogram (YUV) (IC 7770) error
14 = Sound processor I²C error (TDA9855)
16 = Main Tuner I²C error (IC 1125)
17 = PIP Processor I²C error (IC 7350)
18 = PIP Tuner I²C error (IC 1127)

I, too, have the 6 blinks of a red light. I found another person online that suggested that perhaps the power cord was "defective" as it's a common issue. I replaced the power cord with one from an old computer (they're the same cord) and it seems to be OK now. That's all I can offer you at this time.

Testimonial: "Thank you for your help, I will give it a shot!"

SOURCE: my philips lcd tv has sound but no picture what is

change the backlight (cold cathode light) on your monitor.. If you are able to open the back of your lcd monitor carefully, the backlights are located at the upper and the lower part of the edge .. replace it with conventional cold cathode lights(protective tube was removed)... there are also instances that backlight was good but the ballast transformer is burnt. Replace the ballast. Its very cheap to replace that.