The wind broke a leg in 2 pieces. Where can I get a replacement leg. My canopy is less than a year old. It is a 11x11 Wilson & Fisher beige pop-up sun shelter

Help in the links, albeit generic.

https://www.google.com/search?q=Wilson+and+Fisher+10%27+x+20%27+party+pavilion

..

notify them with that request

For sale at the web link shown here:

http://www.biglots.com/product/westwood-7-piece-replacement-cushion-sets/svc120026


Wilson Fisher Westwood 7 Piece Replacement Cushion Sets Big Lots

Wilson Fisher 1-877-779-1258

if it's within 2 years old it's covered.
Call toll free: 800.460.2922
Email : [email protected]
Fax: 310.496.0988

Hours: Mon-Fri: 10am-7pm EST

http://www.bugaboo.com/all-products

Need assembly instructions on Wilson and fisher pop up sun shelter 10 ft by 13 ft by 8

I need instruction for 10x20 Party canopy was not in the box

How to set up an Ozark Trail 11ft X 8ft Dining Canopy
It is best to have two people assemble this.

Rods:
4 Side Gables: 2, 2b
3 Rafters Across: 1, 1b. 1b
4 Legs: 1, 1B & 3B

The pieces were not labeled so I used a label maker and permanent marker to label the rods and connectors. The plastic connectors do label the legs and gables but don't label the rafters.


1.Connect a 2 and 2b rod to create a Side Gable. Repeat with the other three 2 and 2b rods.
2.Insert the four Side Gables into the two unmarked connectors (written with a G) to make the pitch of the roof.
3.Connect a 1 rod with two 1b rods to create a Rafter. Repeat to create two more rafters.
4.Insert two Rafters into the 4 corner connectors (written with an R) to form a rectangle frame.
5.Insert the last Rafter in the center connectors to support the peak of the roof.
6.Connect a 1 with two 1b rods to create a leg and repeat to complete the four legs.
7.Inset the legs into the four corner connectors (written with an L).
8.Place the canopy on the frame and use the Velcro tabs on each end to secure in place.
9.Place the hooks (attached to ropes hanging from D Rings) into the appropriate hole on the legs to keep it tight.
10.Stake the canopy to avoid it blowing away.

When assembling alone, put the leg segments into the plastic connectors; pull the canopy over the short frame, then walk around to add the additional leg pieces.

Call Wilson & Fisher and get the to send you the instruction sheets .

Can do this either by conputer or fax.

I didn't have my instructions either, but I finally figured it out. I do the top first. I'm 5'2" and I put it up by myself and this works for me. The leg connections are 6&5 with 6 being on the bottom with little holes near the base stand and 5 being on top. Add the corner connectors and side connectors to tops of 5. Out from the corner connectors add your 7's. Out from the side connectors the 10's for the long side and 8's for the short side. For the top corners add 4 then 3(it is that funky looking rod). In the middle connector add the 11& 12(this will be for the long sides).You will connect corner and sides with 1 (make sure to put the sliding connector on the rod with the Y's at the ends. On the top, top add the last rod. I think you'll be able to figure out how the canopy drapes. I hope I've given the right directions for yours. I put mine up yesterday.