What is required power capacitor for lse 1055 whirlpool

I think screen gone on the tablet

France.

They are now French.

France

Possible that the power supply has failed, if so check the fuse, the surge capacitor or the mains capacitor, rectifier or the drives in the board. If the fault seems centered into the board, then it must be replaced.

The E3 error may indicate that there is a problem with the washer software or the touchpad. Try to reset the unit following the reset procedure.
Disconnect power to the unit and wait 30 minutes.

You haver the operating manual at the link given below.
Download it and you can read with the help of any pdf reader(http://get.adobe.com/reader/otherversions/)

The operating manual link is given below:
http://www.eserviceinfo.com/index.php?what=search2&searchstring=whirlpool

you need to replace the rtc overload contactor located on the compressor body,there is also a run capacitor on the contactor,replace this along with the rtc contactor,this is your problem,the contactor and overload give the compressor starting power and run power to the windings,if the capacitor is bad it doesnt have enough torque to overcome the power to turn the compressor initially

This is often the capacitor charge on the side of the electric motor pump gone bad (which requires the whole motor to be replaced). check power to the motor with a volt meter. if you have power when you select the pump on, and no jet activity in the tub, then you have a bad motor.

It requires phantom power. You need to use a balanced XLR microphone cable. Here is a link to info:http://www.akg.com/site/products/powerslave,id,1055,nodeid,2,_language,EN,pid,1055.html