There is very little that you can do about this except replace it. If it is new you may be able to get a warranty replacement. The internal parts are very small and contain chips.
SOURCE: Which brand of universal remote control works for WEF2702 27" TV?
Try to call the phillips costumer service first!
SOURCE: Viper Directed Electronics 479V Remote Gen 2
sounds like there is a problem with the remote itself. Your best bet is to purchase a new one and program it to the remote start
SOURCE: I lost my Comcast 3 in 1 remote. How do I get a
i need to progrem my tv for the volume i have a comcast
SOURCE: replaced battery in remote even though old battery
•
Resynchronization may be necessary due to the security method used by the remote keyless entry system.
Resynchronization may be necessary due to the security method used by the remote keyless entry system.
The transmitter does not send the same signal twice to the remote control door lock receiver (RCDLR).
•
The RCDLR will not respond to a signal that has been sent previously.
This prevents anyone from recording and playing back the signal from the transmitter.
•
Resynchronization may be necessary under the following conditions:
-
The battery in the transmitter is very weak.
-
The battery in the transmitter was replaced.
-
The battery in the vehicle has been in a low or no charge condition for an extended period of time.
•
In order to resynchronize the transmitter with the RCDLR, perform the following steps:
1.
Stand within 1.5 m (5 ft) from the vehicle.
2.
Simultaneously press and hold the LOCK and UNLOCK buttons on the transmitter for 7 seconds
SOURCE: My 2008 Jeep Wrangler Rubicon has starting
I have the same problem move the shifter to neutral and it starts every time I think its the neutral safty switch
42 views
Usually answered in minutes!
×