I suspect it your spyder. The triangle unit that attaches the inner drum to the hub. See if the inner tub wiggles without moving the outer drum. Answer back
How old is it if you have replaced shocks it’s probaly the bearings which is not an easy job to replace you have to strip it down to find bearing and replace bearing are cheap enough but it’s a long slow proscess not worthwhile getting somebody to do it for u it will cost 100 +
SOURCE: Kenmore Waher spin cycle out of balance
Sounds like your front to back spring is pulling to tight, sometimes you need to replace it and sometimes you can take it off and stretch it. hope this helps
SOURCE: Tromm Washer Model # WM2277HW by LG
will it spin after it washes if it does not then your belt might be broke
SOURCE: spinning cycle
usey only takes about 2 tbs soap ather than that bad main board make sure you have cold water going in washer
SOURCE: Kenmore front loader goes off balance
My front load kenmore washer tub bounces really hard before going into a full spin. can anyone tell me what is wrong with this. thank you
SOURCE: I need the user manual for my lg tromm wm2277hw
for a drain and spin : turn unit on hit spin Button 1 time then start/pause button
this a drain and spin only..
183 views
Usually answered in minutes!
×