I have Simpson ezi sensor SWT 85561, but it doesn't turn on. Already checked the plug, main boards. Everything is fine. Have no clues why it's not on.

SOURCE: Vizio P42HDTV Power on Diagnosis

Please check the U29 8 pin little surface mount mosfet it has this letters > FDS4935 > > In this part inputs 13.2 volts which is ok for the near 12 vdc but it > outputs 1.250 vdc i am 100% sure that this is all the problem > > check it out, and tell me if you´re agree with me > > On this output pin it feeds the audio Ic, the 7809 and the tuner side board > which needs de 12vdc too and its getting only the 5vdc part > > what do ya think?? > > Richard

SOURCE: Electrolux/Simpson EZI sensor 5.5 kg machine cycles.

Well I'm an idiot. They did say there was a fast wash, but it specified that it was for extra rinses to help people with detergent allergy etc., but did not give a time for the cycle. They should have said it was the short wash for everyone. I tried it, and it was fine. Thanks anyway. If I ever have a real problem, I'll be back.

SOURCE: We are using our Electrolux/Simpson Ezi Sensor washing

also have the same machine - if you wash with the eco rinse the clothes will ALWAYS have the soap residue on them and if you use the deep rinse then this machine will just sit there doing the very occasional agitate for up to 6 hours - can't win - have only just hung out a load and as usual there are many many dry spots on the sheets which is a daily occurence - really hate this machine and it's so called u-beaut functions -

SOURCE: simpson ezi loader washing machine clicks 3 times

Hello,
It sounds like a door switch fault see if the end light and the start/pause light are flashing count the flashes if end flashes 4 times and the start/pause once or maybe more this could be error 41, door switch fault.A door switch would cost about $ 20 but there may still be a problem with the main Programmer.
Good luck.

SOURCE: sony vpl cs5 projector will

Have you tried the following:

Connect the power cord and turn the projector to standby mode.

Press the following keys on the remote commander in the following order for

less than five seconds each: RESET, <,>, ENTER.