SOURCE: cold water will not run into washer, but drips when washer is off
Take the hose off the back of the washer and remove the screen and you will find it to full of sediment. Clean it out and try again.
SOURCE: washer overflows
water valve maybe bad.but take screws out of face of machine and lift the face to see if your vacuum hose is pinched or pulled off from water level switch.also check to see if vacuum hose is on tub of machine.
SOURCE: cold water won't run into washer. warm is fine,
Hello.
If the cold water will not run into your washer you will need to replace the water valve on your unit.
SOURCE: cold water run into washer slowly. Pull off cold
water may flow fine through the hose itself, but you prob. have a damaged water inlet valve on the washer.. ( what the hoses are conected too... hope this helps...
SOURCE: washer runs but the water does not turn off,
while machine is filling turn of power if the water is still entering machine you have a mechanical fault water valve hot or cold needs replacing if water stops when power turned of you ave an electrical or control problem check water level hose from tub to level switch for damage or perishing if ok check water level switch blow into it see if it clicks if not replace also while blowing hold pressure to see if the diaphragm in the pressure switch is not perished keep me informed
Testimonial: "Great information. I will helpbme locate the problem in a rather than just hunting. I will order the replacement parts and let you know"
93 views
Usually answered in minutes!
×