Here is a forum that may answer your questions.
https://forum.millerwelds.com/forum/welding-discussions/567309-millermatic-211-auto-set-wont-feed-wire
SOURCE: My 211 Millermatic welder is
Your problem rely on the initial settings, your voltage is too high or your wire feed speed it's too slow. Compensate both, or just decrease you voltage.
SOURCE: millermatic 211 temp light flashes when machine is
Hi:
By the description sounds like the trigger itself is the problem, have you try to bypass (bridge) the connection (disconnect the gun's plug from the machine and use a clip to bypass it at the machine's end) and see if the problem persists?
If the problem continues, then the problem would be the heat sensor.
SOURCE: New welder, only fed wire a couple times now it wont work
wire cannot be rusty as this rust comes off and jams the wire in the tip as well
Testimonial: "Its not jammed, the rollers dont roll to even push the wire when you pull the trigger"
902 views
Usually answered in minutes!
×