Error code 02 on a newly installed Bosch Nexxt Washing machine

means that the computer is seeing the door as opened even though it may be closed, you can fix this by following this guide:

Bosch Front Load Washer Error E01

Hi and welcome to Fixya, The E01 error for your bosch indicates a door lock problem has been detected at the control board. Insure the door is closed tight, turn your breaker off or unplug the washer for a couple of minutes and retry. Let me know what happens, ultimately it may be a faulty lock assembly, a loose wire harness etc. but we'll cross that bridge when we get there...if necessary. I'll watch for you to respond with the result's. Good luck. Macmarkus :)

ASK BING .COM

looks like a heater failure it statrs to heat at about this time into wash mode.

Possibly the outlet filter , but maybe the inlet jets are blocked , check in soap drawer roof

Put the washer on cold and run "TWO" cycles. There is too much soap or fabric softner.

Hi. I had the same problem with my Bosch washing machine and called Bosch...was told the same thing...$99.00 for service call. I managed to fix my problem by doing the following:

• Removed hot & cold water supply hoses.
• Took filter screens out of both hoses.
• Removed filter from cold inlet on back of washing machine. I noticed some oily buildup on both of the cold screens so opted to not put any of them back in.
• Then I put hot & cold water supplies back on the wall hookup, but crossed the lines where they came into the back of the machine intentionally so that the hot water line fed into the cold side of the washing machine and vice versa.
• Then I ran a couple loads on "cold" which was actually hot water coming in to the machine.

The reason I did this was that I figured there must be some more waxy buildup inside the machine in the cold lines and hoped the hot water would melt it like when you rinse a greasy pan under hot water. IT WORKED!!! I hope this helps you.

Sounds like a baby sock stuck in the drain. Remove the access door bottom right. Reach in and unscrew drain cover slowly and a little at a time. Put a sheet pan under it to catch the water as it drains. It’ll fill the sheet pan a couple of times so have patients. That’s where your clog will probably be.

If you have had the washer for awhile you should clean the sediment filters, where the hose goes into the back of the machine and where the fascet and hose connect. The cold water side usually collect more sediment. The filter screens are delicate so be careful pulling them out.