Just guessing, but are you using a presser foot and needle plate that will accommodate a zig-zag stitch? Some machines are so smart now days, they won't allow anything but a centered straight stitch with a straight stitch foot or needle plate.
I had the correct stitch plate (9mm) installed but I didn't switch the setting on the machine when I switched out the straight stitch plate for embroidery when I completed that project. I was getting a Warning notice but I didn't realize it was regarding the wrong plate since I had changed it already. I failed to go into the software and select the 9mm plate! My bad!
Well, it's great you were able to figure it out!!!
Thanks so much for this post! That's just what I did!! Hugs!!! :)
×
529 views
Usually answered in minutes!
×