I get an E4 error message when I turn on the machine.

E4 Overflow

Sometimes during trasport it is possible that styrofoam float mechanicaly activated overflow microswitch. So, you should check complitely overflow system.

At any time, if overflow micro-switch act and keep for longer than 2 seconds, the E4 would occur. When E4 occurs, the drain pump will run until flowmeter keep motionless for 2 minutes (if the model with the pressure switch (83/63),drain pump would run till the pressure switch reset and continue draining for 60 seconds.) and all the other components will be stopped immediately. At the same time, the buzzer will alarm for 30 seconds and error 4 will be shown. Note: Priority level of E4 is the highest. E4 operation is valid after other error operations have done. When E4 operation has done, all the others are invalid.

Dado

I am having difficulty with my logik slimline dishwasher. E4 message about 30 minutes into cycle. Where the salt goes is always full of water. Please can someone help me

Hi,


The error code E4 means selector switch pads is stuck.
First try a hard reset. Unplug the unit for 10 minutes and then switch on the dishwasher. Most cases you won't get the error message.
If you still get the error message then you need to take to service center to get it repaired. Mostly, the inner connectivity between the pad and circuit board is loose/bad.

Hope this helps.

Shane

e4 error code that means it ihas defective base unit. it happened due to a spike in the power lines that may cause this error

All sewing machines are 'picky' about being threaded correctly. As you seem to understand. There is no shame in asking the seller for help.

take of the btwo black panels at the bottom of the dishwasher and put in a towel to soak up thje excess water this works for me everytime

call manufactor and see if your serial number qualifies for a firmware upgrade.

take off two black covers on bottom front of machine and mop up or soak up any water you feel or see at very bottom of machine by a polystyrene float this will fix it

e4 for most products means it must be reaplaced contacted the company they should be able provide a replacment