HP office Jet 8600 paper tray came out and can't get back in

SOURCE: Paper jam in HP 4255 office jet all in one printer

Clearing paper jams
Paper jams can be real or false. The unit may report a paper jam even when there is no jammed paper. The solution to a real paper jam or a false paper jam is the same.
CAUTION:
Jammed paper must be removed using the rear access door with the power cord disconnected to avoid mechanical damage. Do not remove jammed paper from the front of the unit.

1. Turn off the HP product and turn it around so the back of the unit faces you.
2. Disconnect the power cord from the back of the all-in-one. The power cord must be disconnected to allow the paper feed rollers to turn freely.
3. Locate and open the rear access door by pressing in on the left side tab and then pulling the door toward you.

1. Inspect the pressure rollers on the rear access door and verify that they are clean and turn freely. Clean the rollers if needed with a soft towel lightly moistened with water. If the rollers do not turn freely, replace the rear access door. Click How to Buy on this page to order replacement parts.
2. From the rear access door opening, remove the jammed paper.
3. Remove the remaining paper from the paper supply tray. Discard any paper that is damaged or crumpled and then re-stack and reload the paper into the paper supply tray.
4. Reinstall the rear access door.
5. Reconnect the power cord to the unit and turn the unit on.

• Never use paper that is torn or wrinkled.
• If you are having problems using paper that has already been printed on once (recycling), replace it with new paper.
• Remove and then reinstall the rear access door. Verify that the access door is fully locked in place. The paper can skew if the rear access door is not locked.
• Every six months to one year, clean the paper feed rollers with a rag lightly moistened with water. Over time the paper feed rollers accumulate dust and do not function as well as they once did.
• When printing envelopes, tuck the flap into the envelope and crease the folds before printing.

SOURCE: paper jam

HI THERE,

try to turn off the unit & unplug the printer for a while. check again for any stuck object/part or any debris inside the printer.

let me know here again.

thank you

SOURCE: Paper in lower tray is not being "grabbed" by rollers to start the print or fax job.

I think you need to add some paper to it so that the printer will easily pick them,,,,or arrange the paper onto the tray..

SOURCE: I need an HP office jet 6210 paper tray

ebay.com type in HP Paper tray They are around 20 bucks and you could get it less then a week. hope this helps hun

SOURCE: In our office we have

From the P4015 manual --

1. In the software program, specify the source tray, the paper size, and the paper type.
2. Send the job to the product. If the tray needs to be configured, a prompt appears on the
control-panel display.
3.If the displayed size is not correct, press the back arrow the correct size, or highlight CUSTOM.
Press the down arrow to highlight
To specify a custom size, first press the down arrow to highlight the correct unit of measure.
Then set the X and Y dimensions by using the numeric keypad or by pressing the up arrow or
the down arrow .
4.If the displayed paper type is not correct, press the back arrow
to highlight the paper type.

Hope this helps.