- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
https://www.allclaveparts.com > error-code-e009 > e0...
Midmark M9 & M11 Error Code E009 Door Does Not Open At End Of Cycle · Remove any debris or buildup from Latch Lever & Pulse Solenoid Mechanism · Remove burrs; ...
Providing a make and model would probably help you get more answers.
If you are referring to a SES2000 or LS3, ELECt means power has been removed during a cycle and to clear the error, turn the power off, hold one of the 4 buttons on the front as you power the autoclave back on.
You will have to re-process the load as it has not performed a full cycle.
Error 3 is a Door lock error and has nothing to do with the water sensor. Tighten the door down snuggly, but don't over-tighten. If it still doesn't work it may need a door rebuild or switch replacement. Call for service if it doesn't restart.
The E13 error code on an Enigma 8 autoclave typically indicates a problem with the vacuum system. This error code is indicating that the vacuum is not reaching the proper level during the sterilization cycle.
Here are a few things you can check to fix the E13 error code:
Check the vacuum pump: Make sure that the vacuum pump is functioning properly and that it is not blocked or clogged.
Check the air filter: Make sure that the air filter is clean and not clogged. A clogged air filter can prevent the vacuum pump from functioning properly.
Check the vacuum hose: Make sure that the vacuum hose is not damaged or disconnected.
Check the door gasket: Make sure that the door gasket is not damaged or leaking. A damaged or leaking door gasket can prevent the vacuum from reaching the proper level.
Check the control board: Make sure that the control board is not damaged or malfunctioning.
Check the water level: Make sure that the water level is at the correct level in the autoclave chamber.
×