Need more information. Try lifting up on the handle when you card the lock. A worn or broken clutch assembly is a common issue with older TESA/Onity HT24 locks.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
disassemble the lock and inside the lock is a small silver reset switch with a reset button with red button just simply press it with fresh batteries and hold it till the lights come on and go out and presto your lock is clear and can be reinitialized...
Several things can happen so do the following.
1. With your ear on the door press the remote to lock and unlock. If you hear a clicking sound in the doors open the door panels and see if the locking pins are not detached to the motor that activates them when when you lock/unlocks using the remote.
2. If there is no clicking sound then you are not getting power to the locking system in the doors. Trace wiring from the control unit to the doors.
3. If wiring from control to doors is OK then the control itself is bust. You need to have it repaired (if there are any good electronics techs in you area) or just get a new system installed.
This page is for Onity's Supplies and Services: http://www.onity.com/support/supplies-and-services/ It is the only source of contact information that I could find toward solving your problem. I suggest that you contact them through the phone number listed on this page. For your convenience, By Phone: 1-800-749-2983 By Email: [email protected]
security module in the trunk ???? There is no security module in the trunk . What light's come on by them self ? Park lamps , headlamps , brake lamps ,turn signals etc.... The module for anti-theft is under the right hand side of the dash . The remote keyless entry module is located in the trunk.
Is this the part you hear clicking in ?
Door Lock Control Processor, Electronic
NOTE: The electronic door lock control system will not function when the ignition switch is in the RUN or ACC position.
The electronic door lock control processor:
is located on the LH side of the luggage compartment.
contains a radio receiver that receives a signal from the keyless entry remote transmitter (15K601) through electronic door lock control processor antenna, and sends the appropriate command to the power door locks, the horn relay, the indicator flasher, or the anti-theft warning system.
is equipped with a battery backup which holds the programmed code in memory in the event the vehicle battery is disconnected.
Doors Do Not Lock or Unlock Using Keyless Entry Remote Transmitter
It could be a rusted or jammed lock solenoid or a bad connector to the right door. If you hear just a very light click when you try to lock it, it could be jammed solenoid.
It could be the motor inside the door. Its a 1991 so its been used a few times obviously. Where its the left door its used more then the right. Try the right side and see if it does it?
Could be 1 of 3 different things. #1 the electronic solenoid that controls the lock mecinism has failed. check by feeling/hearing a click in the door when you try to lock/unlock. if you hear the click from that door it means that the linkage is broke or has come apart. If no click it is the solenoid or loose/broken wire. Chances are if it is a broken wire it will be in the plastic tube that runs from the frame into the door.
×