I have a Samsung front loader and it is not filling up with water very quickly

It means "No Fill". NOt enough water is making it into the washer. Make sure your water connections are good and hoses are not kinked.

could be motor brushes or capacator

I can not see the entire front of your machine, are you sure its over filling? I use a front loader also, at the bottom of my front loader is a small door, when I open it there is a drain pipe inside, sometimes the drain needs to be cleared. I am hoping this is your issue and that this is a quick fix for you.
If not, you can check the back of your washer where your water hose connects to washer. Inside the hook up is a screen (on your washer) sometimes these become clogged due to mineral deposits in the water.

your using to much soap. use 1 tablespoon of detergent. too much soap will cause spots. depending on which cycle your using . might not be enough water on the rinse cycle. nothing wrong with your washer. i'm a certified samsung tech. hope this helps

For front loaders, they usually have the level underneath the door, they use small amounts of water, but they spin so all the clothes do get
soaked with water.

Thats normal just the water valve

Sounds like one of the water valves isn't opening up. Try lowering the water pressure a bit. You may have to replace the water valves.

E1 : washing machine has exceeded a check time for fill, heat or empty.

Common causes for this are fill and empty problems, heater fault (or the wiring
to it broken), water pump open circuit (although that would stop the water draining too) Pressure chamber blocked or pressure tubing pipe looped below the pressure bottle, or a sticking eco ball in the sump hose (sludge and grease build up)


This error code is generic and vey common.Since you have tried the remedies.Try getting checked the internal wiring damage by professionals.I hope certainly hope the problem lies there.

try pouring boiling water down soap draw possible blockage due to cheap wash powder take off lid and massage down pipe then put on wash with no clothing

could be a bad pressure switch did it fill all the way is it a top loader or front loader any noise or nothing