Cannot record externally from Humax bt you View box onto Toshiba RDXV60KB ( HDD & DVD modes). As I previously could? I am getting message E26 " Cannot record from this program". But the Tos

The device may not produce sound when it is in the fast forward or fast reverse mode. Also, you cannot obviously expect sound when the device is in pause mode. This not a malfunction. However, if the issue is due to other issues the steps below might help to resolve it.

1. Unplug all the connections from your Toshiba rdxv60kb hdd/vcr/DVD player. Reconnect the connections securely.
2. Make sure the connecting cord is not damaged and the connections to the amplifier are secure and proper.
3. The audio will be muted if the setup menu or the timer-programmer display is shown, or if the screen saver mode is active.
4. Check the 'Audio Out' settings if the audio signal doesn't come through the Digital Audio Out (Coaxial) jack.
5. To get a clear picture, try the tips given below.
6. Connect your TV and the DVD using a different cable.
7. Connect the cable to a different port on your TV.
8. Test the DVD with another TV.

For Quick HP Printer support 1-866-293-9220

DVD player AV out to HDD AV in RCA cable red white yellow

HDD input source has to be AV in you may have to set up a timed program chanel to av in av1 or av2

you may not be able to do this due to copyright embedded signals being detected by the HDD

I think you might have a problem with the VHS mechanism. Perhaps damage to the mechanical parts. If the mechanism can't perform the task it has been set after a very short period it will send a message to the electronics to shut down. This prevents further damage to the tape or system.

do a hard reset and if this does not work contact the manufacture or use the trouble shooting section of the manual

Look for a Reset and hold it in/on for 5 - 10 seconds. Apart from that I have no idea sorry, Greg.

I have the same problem - I particularly want the 'dubbing' menu to copy a video to hard disk. I tried a factory reset but it makes no difference

The following is for the RDXV60KB but can be used for the 59 version.
It is worth a trial.

http://www.superfi.co.uk/extras/Toshiba/RDXV60-English-Specific.pdf

Try transferring to the Hard Disk first, then copy to DVD from the hard disk.

I have a toshiba Hdd & DVD / Video Recorder However I can not get it to work with my Sky setr up If I set thimer recording it does not work when I turn it on it will only work pn channels that are not from sky it will not instant record nor will it record programmes prerecoreded of sky HDD it will record everthing other than what I want.

My E-Mail Addres Is fj.gadkey_1@sky .com

My Home hone is uk 01527 545284

After the update to 1.15 I had to delete EVERY recording on the unit. After that, any new recordings would burn just fine. However, some have found that same failure even after a hard reboot (repower). Called Humax level-1 support and they suggested a replacement unit so I swapped it out. But I've since learned that TiVo "pushes" a DVD firmware patch (possible supplied by Humax) from 1.08 to 1.15 and that patch is the culprit. That patch is suppose to make the DVD burn at a higher spin rate. After talking with level-2 Humax support they heard of the problem and said "the unit is working as designed", meaning, the DVD drive manufacturer specs say the drive is capable of a faster burn rate. So now I have Humax DTR800 #2 and so-far-so-good, but TiVo hasn't pushed the patch onto the box yet!