Cabrio washer want start.

Check and see if there is a reset button that needs to be pushed. Not sure if there is one.

CHECK PUSH START BUTTON, THE DOOR SWITCH, THE FUSE TO SEE IF BLOWN

push and hold the cancel button in untill it starts to drain let it finnish draining and stop them it will start again let me know how you get on

That happened to me once. I just unplugged the machine for a few mins and it released the lock when I plugged it back in. I've got my fingers crossed that it doesn't happen again.

Cabrio Start Button Repair

Hi,

If your washing machine will not fill, only hot or cold will fill or is slow to fill then read these tips. I have covered many of the things that can happen in these tips...


Washing Machine Problems No Water

Washing Machine Fix Washing Machine No Water

heatman101

Press STOP/CANCEL to clear the display and completely cancel the cycle

flashes if the washer loses power during a running cycle. The washer does not flash "PF" when it is first plugged in.
Press START to continue the cycle from the moment that power was lost

make sure the water inlet valve to the machine where the hoses hook up is in good working order. if you don't get water in the machine will lock you out.

Your Door switch is faulty or, out of adjustment

Try this:

1. Switch off the power using the 'MAINS ON/OFF' button
2. Press and hold the 'Temperature' button
3. Carry out the next three steps within 3 seconds;
4. Switch on the power
5. Release the 'Temperature' button
6. Press the 'Soil type' button
7. Check that a message similar to "DIAGNOSTIC MODE 123F7F2F5V127" is displayed. If it is not, repeat from the beginning
8. Switch off the power
9. Switch on the power. The fault code should have cleared.