Et1161-05 trying to burn recovery disc. 2nd burn failed. error 431.

yes most times
but we move it to 2nd PC in USB dock and try.
using RECUVA (free) (saved some mine for a fact)

https://www.pcdied.com/HDD-SDD/recovery.html

imagine a newspaper
burned to ashes, no data there! then
now pretend only some pages or holes burn some, yes data but not all.
that is how HDD work, dead or 1/2 dead or fractions
even 1/2 of one fail gone.
if smart tests fail, on the drive run RECUVA on bad drive on 2nd good PC.

You can get a lot of help from www.bleepincomputers.com

You have tried all possible solutions and troubleshooting.

My Suggestion is to check the Warranty of the Hard Disk and get it replaced. this possible shows a mismatch between the Laptop and hard drive.

If the computer is still under warranty, get the faulty CD/DVD-writer replaced, so that you can "burn" disks.

However, you seem to have "other" hardware problems. Hire a qualified computer-geek (Geek Squad or Dial A Geek) to trouble-shoot, if your computer is out-of-warranty.

This is an error that shows that the recovery failed..
try with another recovery disc or try with another recovery disc

My 0xc000000c "Restore Failed" prompt seemed to be the result of disk surface damage on the restore disk. After burning the restore disk to a new disk, the restore proceeded normally. Try making a copy of the original restore disk to a known good blank disk.

Ketanvasu your an idiot....If he's trying to recover the laptop obviously the thing isn't working...so how the hell is he supposed to burn cd's genius?

Did you try to clean the 2nd disk and do it all over again?

Check/clean the 2nd disc if any finger print on it. or clean the laser unit for CD drive if you can and have correct clean liquid in your hand.

Or do Low-Level format your HDD before doing recovery.

If you still can't keep doing recovery after you have done all three steps above, there are some thing else wrong with your motherboard.

Do recovery again, when it asks you to insert disc 2, take out disc one and close the tray. Do not put the disc 2 yet. If you can see the error message again, then it is a RAM issue. You need to reseat the Memory module and try to do the recovery again.

If you closed the tray then no error message came up, it would be an issue with your recovery disc and order for a new one. You can contact Toshiba to have the recovery replaced due to corrupt media.

Hope this helps.