Gyropter makes sound but propellers do not move.

Hi Tyler:
Try using a mechanics stethescope (or a dowel sound rod, thumb over end held against your ear) and with the engine running, touch various components. You will hear different sounds, and hopefully be able to isolate the whine.
CAUTION - Work Safe - moving bits can make the sound rod hurt you.
I'd be guessing at an alternator bearing as they whine worse than a puppy on the wrong side of a door.
Cheers

What exactly are you referring to?
make & model please... please place your answer into the comments of this thread, and somebody in the forum will assist you.

Sounds like the battery is not charged fully. Mine did that after I pulled it out of the box. Let it charge for a while longer.

Chaio!

batterymaybe

Hi,
Mostly all the micro copters problem are the battery and the the pinion gear that's been worn out.
Check both of these part. Battery should at least gives out 350 mili amp. and the gear should touch the propeller shaft gear at the bottom of the copter.

Get a lithium ion battery for more power and longetivity.

Hope that helps!

Hi,
Check the charger adaptor if it has any output power. If no power comes out replace the adaptor.
Check also the battery terminal, it might already corrode and needs clean up.
If all does not work, the battery in the helicopter is already malfunctioning.

hope that helps you out!

I charged my gyropter ,and the bottom propeller spins slowly and makes a noise.

Customer Service give their customer service a call

I solved this same problem by removing the canopy and realigning the helix shaft with the motor gear. The small screwdriver provided will work. Be careful of the front white LED light when pulling the canopy off.

Unplug the unit and remove the motor shroud insert plug back in the outlet.The single most cause of no motor output is failure of the DC motor control. Look for any test lights on the power boards beneath the motor hood.If it operates on an open-loop system, the computer will run normally and not give and error code, but the motor will not turn. If you have a multimeter, you can test to make sure you have DC output from the controller spades if not replace the control board. If you have DC output, but motor is not turning the test the motor itself.
Cordless drill battery- get a fully-charged, 18 volt (preferred) cordless drill battery and on most treadmills connect the red and black motor leads to the battery (some have different colors but if you have two wires and get it hooked up backwards, the motor will just run backwards and won’t be harmed). If good, the motor should operate at about 1 MPH.
Car battery- these are 12VDC high amp batteries so the motor will turn slowly but you can walk on the belt. Always be careful with battery acid on these things so we don’t recommend bringing them in the house…take the treadmill to the battery.
Lantern battery- a fully charged lantern battery should operate your motor at a slow speed but lacks the amperage to have someone walk on the belt. If it does not rotate replace motor