The display screen does not display the first two characters of each line.

Contact the maker/dealer direct for a new display. If you are good with a soldering iron, strip it down and look for a blown capacitor on the back of the display board.

SAM4s ER-650 Cash Register

https://www.cashregisterguys.com > samsunger650
Product Description · The Samsung ER-650 features an Eight line x 20 characters per line LCD screen · On-screen programming simplifies programming of menu items ...

Turn key to "PGM"
Press "7"
From the
LOGO DESC. PROGRAM screen, press "0" to display the PREAMBLE screen:
Using the alpha numeric keyboard overlay, type the first line of the message.
Each line (6 allowed) can be up to 32 characters, although only the last 19 characters you have entered will display. If you make a mistake, press the "BACKSPACE" key to erase the previous character. After you have completed typing the first line, press "ENTER"
to accept the new line and advance to the second line, or press
"ESC"
to return to the LOGO DESC. PROGRAM screen without making any changes.


Thank You
Team
ACP ONLINE

1) use a pin to press and hold "reset" to clear the display
2) press and hold "S" to get a blinking underline
for each letter, press the "C" triangle until you see the letter you want, then press the "E" square to enter that letter and advance to the next letter. when done, just wait for it to timeout.

I'm unsure how to display things more than 16 letters.

I would call the dealer to see if this is the norm.

Hi
its not the screen its the Ram and the oscillator that need to be replaced this is why you see this characters
[email protected]

It sounds like you are displaying some or all formatting marks.

As shown on Microsoft Website:

1. Click the Microsoft Office Button , and then click Word Options.
2. Click Display.
3. Under Always show these formatting marks on the screen, clear the check boxes for any formatting marks that you do not want to show in your documents at all times.

The printwheel may not snapped in properly and going to it's home position. . Keep trying..it will spin to its home position when installed properly, providing its not broken or bent. The other problem may be the ribbon may have a bind in it or be out of ribbon. There is a wheel or hole on the ribbon to mover to tightened it up. try that
Squipps

Programming is done on 7310, 7324 and 7316 type sets.Enter programming by pressing the feature key followed by **266344.When prompted to enter the password enter 266344.
The screen should say TERMINALS&SETS. The 4 top line/feature keys are now used for programming.
At the terminals&sets prompt, press the show key (top right arrow). The display should now ask for an extension number. Enter extension number you want to change the name on.
Press the show key (top right arrow)
The display should say LINE ACCESS
Press the next key (bottom right arrow) .
The display should say CAPABILITIES.
Press the next key (bottom right arrow) .
The display say NAME.
press the show key (top right arrow)..
The name can be a maximum of 7 characters
Press the next key (bottom right arrow)when finished entering name. Press the release key when finished

sir if u wants to type the special characters then press the shift key before pressing that button.

need instructions