U-Line 75WC Wine Cooler Logo

Related Topics:

c
clarencecsto Posted on Feb 07, 2014

Unit not running; thermostat wires jumped and it runs. Replaced thermostat and it ran for 5 minutes then stopped. Jumped thermostat wires again and unit started running. Any suggestions?

1 Related Answer

Anonymous

  • 93 Answers
  • Posted on Mar 02, 2010

SOURCE: U-line 75R was not cold. Shorting the two wires at

This U-Line does not have defrost timer, check the wire connection on the thermostat or you may have a bad new thermostat.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

1996 ford tbird fan runs at high speed once engine is started.

Have you tried changing the fan relays? Sounds like they may be stuck on.
1helpful
1answer

Transmission or altenator?

I would say change the alternator out. Start with the simplest and cheapest factor first. Without the alternator keeping the engine running its hard to put it any gear.
0helpful
1answer

When you jump the car it runs for a little while and then lights dim and it dies. Alternator has been replaced and it still does this.

You could have a bad cell in your battery, autozone or advanced auto can test this for you free of charge. there are other things that can be causing this as well like an exposed power wire grounding out on the frame of your car or an amplifier that powers your subs going bad as well.. best bet is to start with the battery!
0helpful
1answer

Had starting problems and cleaned terminal wires, car started. Yesterday same problem, adjusting wires did not work. Had battery jumped, car started. I warmed up car for 5 minuted before driving. Car...

I would say that you need to replace the alternator. The car was running on the batteries power. When you drove the car, it ran the battery completely dead.
0helpful
1answer

H100id induced pool heater runs for 4 minutes then stops heating

I just solved this about an hour ago. It's the connection from the circuit board to the ignitor. The same thing happened to me that it ran a long time and then it wouldn't. At some point it loses spark. The large wire from the board to thee= ignitor is the culprit. Take the ignitor out and press the two electrodes to about 1/4"-3/8max. Clean the surface plate where it meets the heater and also clean the brass piece on the othe end. Then clean the brass piece on the circuit board. Slide the 2 boots down a little and expose the receptacles. Press them a little with pliers, put them on their respective connections and then slide the boots back on. It started right up and has been running since! This after I bought a new gas valve $178! Let me know if this does it for you.
0helpful
1answer

My 2003 PT cruiser dies at a stop sign and then it won't start

You may need a new battery (alternator will keep it running once jumped but if you stop, the idle may not keep the car powered long enough). If you've never replaced the battery, its about time - they have a life of about 5 years.
0helpful
1answer

Running really rough

Spark plugs, Ignition wiring, ignition coil, or high tension cord may be faulty. They must be inspected one by one and replaced if necessary.
Not finding what you are looking for?

116 views

Ask a Question

Usually answered in minutes!

Top U-Line Furniture Experts

john h

Level 3 Expert

29494 Answers

Brad Brown

Level 3 Expert

19187 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66835 Answers

Are you an U-Line Furniture Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...