I/C LIFE END REPLACE I/C - Konica Minolta magicolor 1690MF All-In-One Laser Printer

You can start by replacing the cartridge.

hi, your printer cartridge is toner empty.chip count is empty so replace cartridge orafter refill replace the cartridge chip

Cyan Image unit The Blue one

1290: End of Life of Part Reached

Problem Description:

The end of life of the Prime Assembly has been reached since it has been working for more than 58 hours.

Corrective Action:
Try the following:

• Replace the Prime Assembly.
  

You will need to replace the Prime Assembly PN Q6670-60062

hi just replace the toner
thanks

depends which part has reached the end of it's life.
If it is a consumable, you will have to pay to replace it.

1>If the toner lite is blinking , it's mean the toner life near to end. In these case please replace the toner cartridge.
2>f the drum lite is blinking , it's mean the drum life near to end. In these case please replace the drum.
I hope it will help to solve your printer problem.

The printer is telling you that some parts are worn-out -- "end of life" -- and your printer either needs to have some parts replaced. Or, replace the entire printer, after comparing the cost with an estimate of parts/labour to fix the old printer.

Along with the instructions for the lamp installation, you should have revceived instructions on how to reset the lamp counter. If not, this operation is listed in the owner's manual. If you can not locate that manual, please confirm your model number and I will post the instructions. Since the counter has not been reset, the TV will continue to show the "error" message.

Dan

I found the answer here: http://office.support.xerox.com/SRVS/cgi-bin/webcgi.cgi

Resetting Transfer Roller Life

• Resetting the transfer roller life is to be performed only if the Transfer Roller Assembly was defective and or the assembly is replaced before an end of life or near end of life message. Not to extend the life of the assembly. Doing so may cause premature failure of other internal printer components.


• The printer will prompt the user to reset the life counts if the assembly is replaced after receiving a Replace Transfer Roller or Replace Transfer Roller Soon message.

    Note: If the main Menu does not appear on the front panel screen and only Replace Transfer Roller is displayed, there may be a print job that is either processing or currently printing. Try the following steps to clear the print jobs and reset the Transfer Roller life:

1. Press the cancel button several times to flush processing jobs from the printer.


2. If you do not receive access to the front panel menu by doing this, power off the printer and disconnect Ethernet, parallel or USB cable from the printer.


3. Turn the printer back on, and while it is powering up, immediately start pushing the cancel key repeatedly until you receive access to the front panel menu.


4. If the printer menu appears on the front panel screen, follow the instructions below to reset the Transfer Roller life if the printer did not prompt you to reset it:

1. With Menus highlighted press OK.


2. Press the Down Arrow and scroll to Supplies Info Menu.


3. Press OK.


4. Press the Down Arrow and scroll to Exit at the bottom of the menu tree.


5. Now scroll up to Reset Transfer Roller Life.


6. Press OK.


7. Reset Transfer Roller NOW is displayed.


8. Press OK to reset the transfer roller life.