KONICA MINOLTA C353 ERROR CODE C-5102 - Konica Minolta Bizhub C353 Copier

SOURCE: Error code on Konica Minolta C350

There is not a C0876 listed in the service manual. Perhaps it's a C0B76 - Finishing option Punch Unit Board Malfunction.
CAUSE: The shaft on which the gear rides is deformed. The punch unit cannot be driven from front to rear.

SOLUTION: Reform the shaft toward the punch unit rail. This will allow the drive gears to mesh properly so the punch unit can be mechanically driven from front to rear.

SOURCE: multiple copy error

Turn OFF sorting and/or grouping in the finishing tab.

SOURCE: error code c-5102 in Konica minolta c252

Here’s your GEEK-steer …

This thread appears to cover the solution to your problem related to error "C5102: Main Motor’s failure to turn":
http://www.copytechnet.com/forums/konica-minolta/15515-c252-m1-operation-test.html

In addition, here’s the link to “Bizhub C250P” related support downloads:
http://kmbs.konicaminolta.us/content/support/supporthome.html

Hope this helps, and please post back with a status report and/or any further assistance you might need.

"Today's the best day of my life...and NOW you're part of it!"

SOURCE: Konica Minolta C353 has a C4551 error, how do I fix it?

try replacing the imaging unit with a new one not a reset imaging unit

SOURCE: Konica Minolta C353 - Error Message C-4554

Hi,

The C-4554 error identify a Laser Malfunction (K).

You could check flat cable that connect laset to logic unit.

Chech all laser K cables/connections.

If persist you have to change Lasers group.

Bye.

Testimonial: "Thanks for this helpful reply!!"