I have a Disney princess 13 tv with the gold crown on top of it. When I cut the tv on using the remote it allows me to press one button and then after that nothing. Not even using the buttons on the actual tv. Then the tv cuts off after about 5 mins I'm guessing this is because of the inactivity. Somebody please help me. And tell me I'm doing something wrong and that it's me not the tv!!!

Code for p1300ntv to work with directv remote

disney 13" princess tv, any suggestions? You can "manually" find your code by 1. pressing

Hello,
If the input button on your remote is malfunctioning you can still change the input from the TV. There is a white panel on the bottom front of the TV with 4 buttons. The button on the far left side of that white panel is the input button. Press that to toggle to your inputs.
Regards, Tony

Hi:
Frist use your cell phone camera mode to see if remote is putting out IR signal, you should be able to see the Infared led light up on the cell phone display, if it does then remote is good and IR receiver inside the Tv is at fault. Just point the remote at you cell phone camera while pushing a button on the remote.

http://cgi.ebay.com/Disney-Mickey-Mouse-Princess-DT1350C-DT1350P-TV-REMOTE_W0QQitemZ170375289258QQcmdZViewItem

TRY EBAY.

My disney princess tv model P1310ATV uses code 759 with Echostar 6.2 and 6.3 remotes. This code is listed in the echostar manuals as a code for Hisense manufactured TV's.

You've tried all the codes for your TV, but you still cannot get the remote control to operate your TV.

1. Turn on your TV.
2. On the remote control, press TV once.
3. Then press and hold SETUP until the TV key blinks twice, then release the SETUP key.
4. Using the number pad, enter 9-9-1. The TV key will blink twice.
5. Aim the remote control at the TV and slowly alternate between pressing Power and TV. Stop when the TV turns off after pressing the POWER key. This means that a working code has been found.
6. Press the SETUP key once to lock in the code. The TV key will blink twice.

Hope this helps

You can "manually" find your code by  1. pressing tv button on the remote 2. press and hold setup until TV button blinks twice 3. press 991, the tv button should blink once 4. slowly press and alternate the power and tv buttons until tv turns off.   5. press setup to lock in the code when tv turns off.
hope this helps,  j 

On your dish remote, press and hold the tv button until all 4 buttons light up, then release. push either of the power buttons once. Now start pushing the down channel button, It's the one right below select, continue pushing it until tv turns off. When tv goes off push down button one more time then push up button, when tv turns back on stop and press # key, tv light will flash 3 times and should be set. Note....if u press down button and tv does not turn off after going through all codes( tv light will start flashing) press cancel and try again only channel up this time. hope this helps.

disney will replace for around 30 dollars. Google disney customer service and get number is you are interested.