Indesit W 123 Front Load Washer Logo

Related Topics:

Indesit IWDE 12 seem to have a problem! All the lights flashing rapidly on the front of the washer dryer. All previous cycles completed without any problems. The final cycle the machine did flash briefly before starting as normal. Thinking possible loose connection or something but I don't really know where to start! Thanks

5 Related Answers

Anonymous

  • 1294 Answers
  • Posted on Jun 16, 2007

SOURCE: indesit widl126s

Suggestion: Possible your outlet filter is blocked; this needs periodic cleaning, depending on your usage. Clean this out and re-fit. Refer to your users' manual re. where the filter is....

Ad
A

Anonymous

  • Posted on Jul 06, 2007

SOURCE: won't connect to any cycle

Check the water pump / filter, easily accessible from the front. I had the exact same problem and it ended up being some plastic stuck in the water filter... the outlow was backing up and caused the program to abort.

Anonymous

  • 84 Answers
  • Posted on Aug 12, 2007

SOURCE: Indesit washer/dryer widl 126s

Hi gmarf....to reset your machine to cancel those symptoms, Unplug your machine from the Wall Outlet for a minimum of 1 minute. Upon restoring power, it should be reset and ready-to-go.....If you have any further questions or issues please update your post....good luck my friend

Anonymous

  • 2 Answers
  • Posted on Oct 25, 2007

SOURCE: flashing lights indesit wil103

you will need to unplug the machine at the mains, give it two minutes and the auto door lock will release your duvet, however start saving the pennies as your pcb is knackered and you'll be looking at about £200 to fix it

Howard Galley

  • 197 Answers
  • Posted on May 09, 2009

SOURCE: lights flashing on indesit WIL123S

Hi, sounds like you need to change the door interlock located where the door catch pushes into.
Take the top off and undo the two screws with a tork screwdriver
and replace.
(Remember to turn off the supply and pull out the plug top)

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Indesit dishwasher Dfg15b1 will stop during a cycle and the salt light flashes, the drying light stays on, and the start/pause button flashes.

I would check the water inlet flow rate is fast enough as these will time out if they can't get enough water fast enough.
1helpful
1answer

Indesit washing machine

Indesit Washing Machine lWB5113 Flashing Lights(Faulty ...

? 3:34
www.youtube.com/watch?v=-lnfePzPwTQ

Jul 29, 2012 - Uploaded by porracaralho caralho
Indesit Washing Machine lWB5113 Flashing Lights(Faulty).mp4 .... older model- stopped in rinse cycle/flashing power and rapid wash lights- ...

How to repair Indesit washing machine that is Flashing ...

? 0:43
www.youtube.com/watch?v=Q9Yq2Cz8UFE

Jun 26, 2011 - Uploaded by XR600RQJ
Washing machine Indesit starts to flash for longer and longer ...How do you unlock the door when the power is off?? every time i turn it ... My washing maschine ( Indesit WITXL 129 ) had the same problem - 6 from 9 LED lights ..


0helpful
1answer

Indesit widl102 washer dryer has 2 led lights flashin

unplug it for a few minutes and plug it back in again might be a pain but till you can get it serviced it should delete the fault code and run thru a full cycle. hope this helps a little.
Not a true fix just a work around.

best to you.
6helpful
1answer

Lights flashing on indesit WIL123S

Hi, sounds like you need to change the door interlock located where the door catch pushes into.
Take the top off and undo the two screws with a tork screwdriver
and replace.
(Remember to turn off the supply and pull out the plug top)
6helpful
1answer

Indesit WIDL 106 wont start -ON/OFF-Door Led Flashes rapidly

It is a defectiv controller pcb. I think the eeprom on the controller pcb lost its program (happens often on Indesit machines).

The only solution I know is to change the controller pcb, - not a cheap solution.
I have the same problem with WIDL 106.
0helpful
2answers

Indesit washing machine will not drain and carry on with full cycle

Same problem - changed module with no result. Looks like the water temperature thermistor...
0helpful
2answers

Indesit washer dryer stops halfway through a wash....

depends on what lights are flashing this is your fault code
0helpful
1answer

Indesit 126 washer/dryer

I have had the same problem. I thought it was the pressure switch as this is what the error code means - low or high pressure resulting in cut out. I too thought id fixed the problem but it has returned
Not finding what you are looking for?

252 views

Ask a Question

Usually answered in minutes!

Top Indesit Washing Machines Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

Are you an Indesit Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...