Need manual for homelite sx-135 weedeater

Hi Mary,here's a video to help you. How To Reload String on Homelite Trimmer

You should mix 8 Oz. of two cycle oil to one gallon of gas. I put the oil in first and then the gas and it will be mixed and ready to go.

Here is the part you need for your Walbro carburetor.
http://www.ereplacementparts.com/search_result.php?type=search-part&q=01201&manufacturer=Homelite

There should be a half sphere-like object on the bottom of the spool where the line goes. Twist counter clock-wise to remove.

If it is a duel line trimmer then:

Cut two separate pieces of string, about 7 ft. each.

Stick the end of the line in the hole on the inside of spool.

Wind clockwise onto spool, putting the line that is closest to the ground on first.

Once you have winded this piece on, lock the last 4 inches of line through the slits on spool.

Repeat process for second piece of line, locking the last 4 inches in slot opposite the other locked in piece.

Put the spool on the trimmer, feeding the end of lines through either hole on trimmer.

Before you push the spool all the way on, pull the strings out of the locked position.

If it is a single line trimmer: Then just wind a single piece of string clockwise onto spool. This may need to be longer than 7ft.

Jim

What is the correct size of the nylon cutting material - on my homelite bandit SX-135 trimmer ?

Thanks, Bill.

Your SX-135 string trimmer was built by Homeliteand has a model number of UT-20601. That said, your trimmer's primer bulb part number depends on teh type of carburetor it has. If your trimmer has a Walbro carburetor, the primer bulb part no. is 01201. If it has a Zama carburetor (the most likely one) the primer bulb part no. is A01195A.

You can go to the following website to order the part: http://www.homelite.com/service_support/order_parts

Good Luck, hope this helps!

This is for a duel line trimmer. I hope this will help.

Cut two separate pieces of string, about 7 ft. each.

Stick the end of the line in the hole on the inside of spool.

Wind clockwise onto spool, putting the line that is closest to the ground on first.

Once you have winded this piece on, lock the last 4 inches of line through the slits on spool.

Repeat process for second piece of line, locking the last 4 inches in slot opposite the other locked in piece.

Put the spool on the trimmer, feeding the end of lines through either hole on trimmer.

Before you push the spool all the way on, pull the strings out of the locked position. Put cap on and GO CRAZY!

Jim

When you say, you pick up, you bought it or found it. Most likely it is a 2 cycle.

Genarally the size of line for that size of line trimmer is 2.0mm

heres a link for homelite service manual

http://www.odref.com/homelite/string-trimmers/service%20guide.PDF

pg 4 states that fuel/oil mix is 50;1
2.5 oz per gallon