It doesnt announce callers anymore
If your Jabra Extreme2 Voice guidance is not turned on - i.e. you only hear beeps when you power on or a call comes in...
Cause: powered on or off with answer button depressed
Solution:
1) Power off
2) Hold down answer button (the one that lights up Jabra)
3) Power on
4) Release answer button
You may need to repeat.
THX so much it's worked from first time
Thankyou soh much
Thanks you sohmuch
Yesssssss
OMG!! That worked!!! Thank you so much!!!
×
I used your directions but had to hold the answer button down and cycle the Bluetooth on an off a few time to make the changes. Thank you for putting this answer out there.
I had no ideea about having my extrene fixed. Living in Brazil and having an imported gadget fiexed would be a problem. Saved the day. Thanks for sharing the tip.
This feature lets you know who is calling
without looking at the display.
To use this feature, you must:
- subscribe to a Caller ID service of
your service provider/telephone
company.
- turn this feature on (page 24).
When caller information is received, the
handsets and base unit announce the
caller's name or phone number received
from your service provider/telephone
company following every ring.
The unit announces in English only.
L Name pronunciation may vary. This
feature may not pronounce all names
correctly.
L Caller ID service has a limit of how
many characters can be displayed. If
the caller's name is too long, the
handset may not be able to display or
announce the entire name.
L The announcement is heard at the
same level as the ringer volume (page
16, 23).
L If you turn on the answering system
and set the number of rings "2
rings" (page 36), the unit does not
announce the caller information. If
"Toll saver" is selected and there
is a new message, the unit does not
announce the caller information.
6,710 views
Usually answered in minutes!
×