Hy guys, we have an aeg oko lavamat update starlight. first it was showing the c7 error code than we have reset it and it emptied the tank. but when she tries to start the programme she does not load

SOURCE: AEG OKO_LAVAMAT 74620 gave me a code error C7. What is it?

take off the bottom front panel, a booklet is taped to the right side of the panel for the sevice tech it has all the codes

SOURCE: AEG Oko-Lavamat 86820 Update Error code C9

Hello. I got error code C9 on a LAVAMAT 86800. It pumped in water, and it pumps out water. You can select pump in or out....But the motor dont turn. It will not sentrifuge. So I bought new carbon brush'es on the net. One of them were totally wore down. Now it works. They lasted for 10 years.

SOURCE: AEG oko-lavamat 72600 C2 error code,

Hi from retired Englishman in SW France,

'C2' for AEG washers is reporting a 'pump blockage'.

I would gently suggest as a first step that you clean the drain motor/pump lint tray/filter. So many 'faults' are caused by blocked filters and many machines will not even go to rinse or spin or release the door lock if there is any water still left inside.
Here are my complete and generic guidance notes for checking both the drain motor filter and the drain motor ;-0)
If you are unsure where the filter is, it is often behind the front lower (kick) panel (or in some machines at the rear in an awkward position!). These panels are either held on by (plasic) screws or will just pull off. Most filters are held in by a round cover/knob. Sometimes the filter will not come out with the cover and you will have to persuade it to come out to play.

REMOVE POWER AND ENSURE YOU HAVE A WATER RECEPTACLE/RAGS TO SOAK UP THE WATER WHICH IS BOUND TO POUR OUT (alternatively use a wet vac as sensibly suggested by VinnyB1234!)
It's surprising what people have found in theirs! It is always worthwhile checking it on a regular basis.
Now- whilst the filter is removed it is normally possible to see the drain motor and ensure it is not jammed by a foreign object such as a needle or a toothpick. It should be able to be turned by hand/finger- the power IS OFF!
At this point it is also possible to test if the motor works. No clothes or water in the machine, select a spin cycle and put the power back on. You should be able to see the motor turning at some point, possibly straight away. Using something suitable like a glove see if it is easy to briefly slow the motor down. If it is easy then the motor is malfunctioning.

If this has assisted you please consider a 4 thumbs up for the rating.
Thanks and good luck!
John C

SOURCE: oko lavamat 74640 update showing error E20 what

its a draining error, check sump, pump and drain hose for blockage failing that it needs a new pump.

SOURCE: aeg oko lavamat 72600 update, ce error code

error code ce is a faulty water distributor fault . you have to replace the top part of the soap dispensor compartment. sometimes you can hear a clicking noise when its trying to operate

Testimonial: "Cheers thanks very much, washer now working, great help"