Strange noise while turning on printer: http://www.youtube.com/watch?v=eat8diO9i1c&feature=youtu.be same noise while printing: http://www.youtube.com/watch?v=i7ETqbRtWi4&feature=plcp Sounds like some kind of plastic is touching some cog wheel or roller. Really can't define is it something near multipurpose tray/fuser side or in the middle where imaging units are, but visual inspection of those parts didn't get me any clue... It started after drums were reset and transfer roller & fuser cleaned from paper dust by minolta technicians. Prints are OK but the sound is really annoying :-(
Have them come back? or try a different company
SOURCE: Minolta 2530 DL duplex paper handling
also check that you installed the duplex correctly, that the gears fit into right place. gears are making this sound
SOURCE: Reseting counter after installing new image transfer roller unit
You need to go into tech rep mode to reset.
press: stop 0 0 stop 0 1, then 0 0 0 0 0 0 0 0, press enter, then press counter on the left, select life, then highlight image trans roller and press the C button, repeat for paper dust remover and exit tech rep mode
SOURCE: My 2300W prints a second image
Yes, it sounds like a fuser problem, as the oil and coating wear off of the fuser rollers they transfer to the page as you describe. The only way to tell is to stop the machine in a print cycle before the fuser to determine if the problem is before or after the fuser.
Testimonial: "Very helpful and obviously knowledgeable gentleman"
SOURCE: Replacing Image Transfer Roller Unit & Paper Dust/Ozone Remover
hi this unit located in the RIGHT DOOR
SOURCE: cleaning dust off of mirror inside Konica minolta
www.rangefinderforum.com/forums/archive/.../t-5895.html
Watch this videos tips:
http://www.youtube.com/watch?v=qgb2TY3WCkg&feature=related
http://www.youtube.com/watch?v=-oeXTKqWECw&feature=related
http://www.youtube.com/watch?v=GPI6dFJCUA4
http://www.youtube.com/watch?v=bF3OyQ3HwfU&feature=related
http://www.fixya.com/support/r10724803-measure_voltage_in_transforme_fitness
http://www.fixya.com/support/r10786838-test_procedure_dc_motor
http://www.youtube.com/watch?v=23ZgWaVEQjA
Test the motor and repair+flywheel+belt
We have the same problem with many other with your washer.
You can have a look to the videos below
http://www.youtube.com/watch?v=HQCS3emiOpc&feature=related
http://www.youtube.com/watch?v=CmzMYfM7Ehw
And others
And compare to the one below which the last model which mean that whirlpool know the problem with previous models like your with loud noise and vibration.
http://www.youtube.com/watch?v=QczlYr5glsA&feature=related
You can try to unjust the feet and find a vibration elimination floor to put under just to minimised your problem but still a design problem from whirlpool engineer.
172 views
Usually answered in minutes!
problem solved. black toner was full of little toner balls & clusters so the toner input mechanism (somekind of cog wheel) between toner cartridge and drum wasn't working well. little vacuum cleaning of that place and changing toner cartridge helped
×