If you push the play button on the dvd player it does not work

1: Get a movie and some popcorn.
2: Make sure the DVD player and the tv are turned on.
3: Push the button on either the front of the player or on the remote to open the player door to load the disc.
4. Put the disc on the tray that pops out
5. Push the same button pushed previously to close the door
6. Enjoy the movie

You may have loose cables. Check all your connections first. You can also check the "Saturation" setting in your "Picture" settings.
If this was helpful, please rank me a 4.

Hi, Very sorry for your loss. As always the first step is to make sure the player is connected to the wall outlet and turned on. To put a disk in the DVD you should push the "Eject" button to open and close the tray it looks like a home(a triangle over a dash) on the front side of the box down left corner of the tray. You have the same button on the remote marked "Eject". Push either once, put the disk with the shiny side down on the tray and push the Eject button again to feed the tray back into the player. Usually the disk starts automatically and you will see a menu on the TV with alternatives like "Play the movie", "Setup", "Scenes",... you may highlight the "Play the movie" alternative, using "Up", "Down", "Left" and "Right" and then press the "OK" button. Or just push the "Play" button either on the box or the remote control. If you click "Here "you can download the manual in PDF form. To open it in your pc you'll need "Adobe Acrobat Reader" (or any other PDF reader) installed.
I will gladly answer your questions Best Regards Bruce

push button p.scan three time with disc out

try resetting defaults
Place DVD player in standby mode
Push in the stop button on the hardware unit and keep pushed in
Push in Standby button on the remote provide while doing the above
Then put into standby mode again insert your DVD and see if it changes.
All Happiness

I couldnt get the blue ray format of kung fu panda to play in my sony blue ray dvd player. the previews and the menu screen run properly, but when i push play movie, it shuts down the dvd player. can anyone help?

I had accidentally pushed the button for resolution so the resolution was to low.
I repeatedly pushed the button until I got back to the resolution that the DVD player needed to be at. Thanks.

push enter key to play movies if play button doesnt work

None of the buttons are working at all. We can not play the movie unless we use the remote.

TRY PUSHING the ENTER BUTTON on remote TO START MOVIES THAT DONT ALLOW MOVIe to start when play button is pressed.