"AMP" button on Sony RM-VL 900T stopped responding

The programming code for the Sony BDP S500 to be used with the RM-AAP013 remote is 31758. Here are the steps to program the remote:

1. Turn on your Sony BDP S500 player.
2. Press and hold the "S" button on the RM-AAP013 remote until the "Amp" button flashes.
3. Enter the programming code 31758 using the number keys on the remote.
4. Press the "Enter" button.
5. Wait for the "Amp" button to stop flashing.
6. Test the remote to ensure that it is working properly with the Sony BDP S500 player.

You will need to contact Sont or a Sont Agent. Its probably more expensive than buying a new TV

To most Sony remote controls, P+ / P_ & Vol+ & Vol -- ; buttons will work, except for other buttons will work. The difference between the Sony remote controls you mentioned here too will differ to these function. http://electronicshelponline.blogspot.com/

Direct Code Entry

1. Press and hold the SETUP button until the red indicator stays on, then release the SETUP button.
2. Press and release the desired Mode button (TV, VCR, etc.). The red indicator blinks, then stays lit.
3. Enter the 4 digit code from the code tables. Note: after a valid code entry, the red indicator turns off. For an invalid code, the red indicator flashes.
4. With your device on, press CHANNEL UP. If the device responds, no further programming is required. Note: If some buttons do not operate your device, try one of the other codes for your brand.

Right at Sont you have the RM-V310 Manual (Online Version)

Direct Code Entry

1. Press and hold the SETUP button until the red indicator stays on, then release the SETUP button.
2. Press and release the desired Mode button (TV, VCR, etc.). The red indicator blinks, then stays lit.
3. Enter the 4 digit code from the code tables. Note: after a valid code entry, the red indicator turns off. For an invalid code, the red indicator flashes.
4. With your device on, press CHANNEL UP. If the device responds, no further programming is required. Note: If some buttons do not operate your device, try one of the other codes for your brand

1. Turn on the component to be programmed.
2. On the remote control, press and hold the S button.
3. While holding the S button, press and release the POWER button
4. Release the S button.
5. Press and release the appropriate component button for the component being set up.
6. While pointing the remote control at the component, press and release the CH + button.
7. Press and release the POWER button.
NOTE: Repeat the previous two steps until the component responds. It may take 70 tries until the correct code is located.

8. When the component responds, press the ENT button.

As far as I can tell, Sony doesn't have any codes for Orion TVs. You can try searching through all of the codes in the remote. Turn on the TV, press and hold the Set button and then press the Power button. Release the buttons. Then press TV button (component button). Press the CH+ button followed by the Power button. Repeat the CH+ and Power combination until the TV responds (powers off, changes channel). Then press ENT. Check if the TV responds to the remote on other functions. If it doesn't repeat the steps from press and hold the Set button.
This can take up to 70 tries.

Alternatively, try a replacement remote for the TV or a USB programmable universal remote. http://www.remotes.com/store/orion/tv1934.html is a substitute remote that should handle all of the functions.

I hope this helps.

Cindy Wells

Check with another amp if you still have this problem then the Sony is faulty. If not repair the amp.

have you consulted the owners manual?