Singer CE-200 Quantum Futura hung up with one stitch in memory

Change the fuse in the plug failing that it could be the inline fuse inside the machine normally near where you plug the lead in, if youcan get to that it is a matter of changing it, and the Hoop must be detachedwhen powering on! Otherwise it will not start. Hope this will help you. Good Luck.

The needle does not center when you have selected a design to stitch-out?

There is a FAQ for Futuras at the Singer Company website that may be of more help.

Before attaching small hoop, turn on power switch to
move the carriage to embroidering standby position, and
turn off power switch.

check troubleshooting in manual

user manual link
http://www.futura-support.com/files/CE200-Eng_Fre_Spa040607.pdf

hope this helps and you get it working soon =)

There is no update containing selectively "Repeat design" feature, there is an update to bring your software to the level that newer machine models have except some functions which cannot be supported by old firmware. You may ask you nearest Singer representative about Futura 2.5.

I think you might have damaged the embroidary arm.

Contact these people for some advice.

Gezina sewing machine
(012) 335 0636

Use a long basting stitch, sew two lines of stitching, and pull gently.

Dear cjnations
Firstly we must all remember that the CE200 is a very particular machine and requires that you follow certain procedures in order for it to run smoothly. When using the small hoop, firstly you must make sure that the small hoop is selected on the screen by going to Tools, Select Hoop & clicking on small frame. Once this has been done and the design selected, you must then attach the small hoop before sending the design to the machine. If you attach the hoop after sending the design, the machine will give you the error message.
Good Luck!

Wow, I finally get to have a solution.
1. Turn the machine off.
2. Remove the hoop.
3. CAREFULLY slide the bar on the embroidery unit to the left.
4. CAREFULLY slide the piece where the hoop attaches toward you.
5. Turn on the sewing machine. The machine should take the unit to "standby" with a click.
6. Attach the hoop with the power on.
7. Exit the Futura software.
8. Restart the software.
This "should" fix the problem, however, you may have to repeat this process more than once to get it to "stick".

I have had similar problems in the past.
Do you hear a noise from the embroidery unit when the misalignment occurs ? If so, I suspect that your issue may be that you have some resistance under the hoop. Is there extra material that may be rubbing on the machine or catching somewhere. I have found that if I use some masking tape to keep all of the extra material from hitting any other parts of the machine or dragging under the edge of the hoop this error does not occur. FYI: I also stopped using the "optimize stitch speed" option at the same time. I believe that material dragging was causing the problem, but I still wonder about the stitch speed optimization feature.

futura software large design stitch