Bosch WFLI 2440 Front Load Washer Logo
Garry Chumbley Posted on Jun 02, 2012

Hello. I have a Bosch wfl12440 washing machine the drum fills with water on any cycle but then stops there is a clicking sound. water will drain but the drum does not spin. any ideas

5 Related Answers

Anonymous

  • 1 Answer
  • Posted on Aug 31, 2008

SOURCE: bosch classixx 1200 express

Not a programme error but carbon brushes on motor.Fixed by local engineer.

Ad

Anonymous

  • 64 Answers
  • Posted on Jun 10, 2009

SOURCE: bosch washing machine will not fill, spin,

If it won't fill it may not spin or drain unless the water level switch is bypassed. I would check the water valve & the water level switch and tube from level switch to tub must be air tight no holes.
The water level switch must kick in to agitate. I'm not sure on Bosch but some work like this..

Anonymous

  • 177 Answers
  • Posted on Jul 17, 2010

SOURCE: Washine machine not spinning

It sounds like a snapped belt or a broken motor. Can you here the motor run? You can access the motor and the belt from the back of the machine. If it is the belt snapped, this is easy to replace yourself. If it is the motor, you will need a repair man.

Anonymous

  • 1 Answer
  • Posted on Dec 14, 2010

SOURCE: Bosch Maxx 5 Washing machine will not wash, drum does not spin.

maxx5, error F63

mnwarfield10

mark warfield

  • 453 Answers
  • Posted on Feb 26, 2011

SOURCE: bosch wfmc1001uc goes through cycle fills and

check drain pump and filter...

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

I have a Bosch 2820 and the water once it starts filling won't stop. Is this a malfunction of the inlet valve?

No its the water censor located inside the machine is blocked,remove back cover you will find a small plastic pipe leading upwards,remove it and clean out the lug it came from with a ear bud or other un sharp device the pipe as well,gently blow into the pipe you should hear a clicking sound this is the water level indicator to the programmer to stop filling, replace it carry on washing eric992
0helpful
1answer

My Bosch washing machine won't turn the bowl

Hi Justene,
i Think its control circuit has a problem.
or the fuse for motor drive circuit is damaged.

please check with electrician.
regards.
nuwan
0helpful
1answer

My 2.5 year old Bosch Nexxtg 500 WFMC3301/UC washing machine fills then drains. Does not complete wash cycle. If I leave off for a couple of days it will fill then drum turns for awhile, but will not...

sounds like heater fault this will terminate program if no heat detected after a short time, hard water will make it worse unless you use a water softening agent.2.5 years for this is not unusual.
1helpful
1answer

My front-load Bosch washer's drum stopped turning. There is a small clicking sound during the cycle. The water fills and drains, but the drum doesn't turn at all. I've tried different cycles and nothing...

Sounds like the motor although nomally would run longer than 2 years...Did you have new motor fitted or just repair ie brush kit to motor....You could check the bely easy...7 years is very good life span for a machine ,,replacement may be best
0helpful
1answer

My washing machine won't turn or spin.

ok on the bottom there is a donut looking connector with holes and it needs replaced unless its belt drivin
0helpful
1answer

Doesnot stop filling water

To javed_iqb904, does the drum actually fill or does it seem like that water is draining out as it's filling?


To neonllama19, if it fills with the tap on and the machine off, it sounds like a defective water valve. If it never stopped filling it sounds like a defective pressure switch or hose to the pressure switch is loose or diconnected.
1helpful
1answer

WFD 2460 will not start wash cycle after it has filled with water

Isolate power and water supply and gain access to the main drum motor. Check for condition of carbon brushes by removing them and repla
ce if severely worn. Check wiring loom around motor and right back to module controller. The clicking is obviously power being supplied to motor via the loom to the motor. finally check for any dry solder joints or burnt areas on the circuit board controlling the motor.
33helpful
2answers

Bosch classixx 1000 washing machine - stops on spin

Washing machine stops at the spin cycle - light flashes. Have to drain water out manually. Happened last week and was then able to run an empty rinse cycle. Machine worked normally for another week. Same problem today but have had to drain water manually from the drum after trying an empty 90 wash and rinse cycle (both stopped on the Spin and flashed). Any ideas? Thanks. x
26helpful
8answers

Front load washing machine would not spin now won't wash either.

Sounds like you have a broken belt or a bad motor. The easiest way to tell if the belt is bad is to reach inside the drum and turn it. If it turns very easily, you probably have a bad belt or something has caused the belt to jump off, such a s a loose pulley or bad bearing. If it feels like there is a good amount of resistance, or a kind of "winding up" noise, then the belt is still on and you likely have a bad motor. Also, you could just scoot the macine out, unplug it, and remove the back cover a look inside to see if the belt is still on the pulleys. Good Luck!
Not finding what you are looking for?

269 views

Ask a Question

Usually answered in minutes!

Top Bosch Washing Machines Experts

Brad Brown

Level 3 Expert

19187 Answers

NOEL
NOEL

Level 3 Expert

8606 Answers

Oliver Street

Level 2 Expert

73 Answers

Are you a Bosch Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...