Osn blocked my humax IR1030 HD receiver

There is a setting in the tuning menu to tune HD channels.

Installation/Manual Search - select Transmission DVB-T2

Try covering its IR window; it may be receiving some spurious IR signal. Do you have a digisender or similar which relays remote signals?

Default is 0000
http:www.humaxdigital.com/me/support

i need master password Humax HD Free

Tern off the device remove LNP cable then tern on the device again without satellite cable and wait for seconds the massage will gone. Reconnect LNP cable and enjoy it again.

its down to the arial i had same problem

Hi,

You didn't fully expain how each device is connected to the others. I don't think you have this set up correctly. Your DVD cannot record in HD so there is no point sending an HD signal to it - it can't process it. This is how I would set it up:

1. Install a 2-way splitter on the input cable
2. Connect output 1 from the splitter to the Humax receiver
3. Connect the Humax receiver to the TV with an HDMI cable
4. Connect output 2 from the splitter to the DVD
5. Connect the DVD to the TV with SCART cable.

This will enable you to watch HDTV via the digital receiver and also provide an input from source (dish/cable) to your DVD player so that you can record.

If you've already set it up this way then it should work. I suspect you've connected the Humax to the DVD and TV and also the DVD to the TV.

Please try this setup and post back if you need further assistance.

how can i insert biss key in humax decoder model: hd free?

when pluged to a power supply it click but does not display power

E-66 FTA services are blocked Your subscription has expired and your decoder has blocked all channels including free to air channels To renew your subscription call your dealer or customer service, see details on ART Info Channel