How to get moisture out of a watch

https://www.youtube.com/watch?v=6HBjmiZbklg

The film is from moisture getting into your watch. Moisture can get in one of 3 ways generally. The crystal if cracked, the crown, or the back. In your case since you have buttons for the mulch-functions of the watch you add a possible place for moisture to enter. Take the watch to a watchmaker or watch repair person. Your watch has to be taken out of the case and the case needs to be cleaned. Next the watch tec. may be able to see just where the seals failed and replace them. We of course do this. Also if the gasket is old or out of shape this is a culprit as well.
Hope this helps, gabe

the crystal is not properly attached it may have tiny opening where moisture goes inside. you have to bring it to watch service center immediately to avoid much bigger problem. i hope i had been helped you.

Unfortunately there is no way to remove condensation moisture without taking watch apart. Any decent watch repair shop will do it for you.

you will need to get it professionally installed since you need to install it properly and have it sealed to prevent water or moisture from entering inside watch . I would say to have it done professionally around 35 dollars. I am pretty sure that the glass is at least mineral .

if you want to try it yourself you can buy online from esslinger or other similar watch parts stores.

Try putting the watch in a warm place for a day or two, to let it dry out. (one maker said that some moisture is not a problem but I guess that is depends on how much "some" is).

If the problem persists, take it to a watch repairer.

Before anything else, put the watch is a warm place and leave it there fore a day or so, it may dry out on its own.

(Some manufacturers accept that small amounts of moisture inside are to be expected, so it may not be a disaster.)

If it proves to be a persistent problem, then its back to the service center!

place the watch in a bag of minute rice for a day or so and check to see when its becomes clear. this tip,i will guarantee it to work in no more than a few days. be sure to loosen the stem and even the back acess to the battery to insure the moisture can escape from the watch

The film is moisture, you may have to remove the back and let if evaporate. You need new seals as it is your sweat that is causing it.