How to replace the Halogen lamp? - Braun Paxiscope XL Opaque Projector - 100522 Projector Lamp

Just look this youtube video, and it can't be more clear.
Don't forget to unplug the hood, or switch it of. Although the halogen lamps are only 12 volt. In the hood are dangerous voltages. How to replace cooker hood halogen bulb or lamp

look in owners manual back index for bulb replacement, it will show and tell you how to replace light bulbs.make sure you wear clean glove when handling halogen head light bulbs because oils from skin will cause halogen bulbs to over heat and blow out, halogen bulbs not cheap.

Lamps, Parking Front Lamp-Lamp Assembly, Taurus
Removal and Installation

1. Remove Headlamp (13008) as outlined.
   

Headlamp Assembly
Removal and Installation

1. WARNING: THE REPLACEABLE HALOGEN HEADLAMP BULB CONTAINS GAS UNDER PRESSURE. THE HALOGEN HEADLAMP BULB MAY SHATTER IF THE GLASS ENVELOPE IS SCRATCHED OR THE HALOGEN HEADLAMP BULB IS DROPPED. HANDLE HALOGEN HEADLAMP BULB CAREFULLY. GRASP HALOGEN HEADLAMP BULB ONLY BY ITS PLASTIC BASE. AVOID TOUCHING GLASS ENVELOPE. KEEP HALOGEN HEADLAMP BULB OUT OF REACH OF CHILDREN.
   Position headlamp switch (11654) and headlamp time delay switch (13736) in the OFF position.
   

1. Remove two bolts retaining headlamp (13008) to upper support assembly and loosen pinch bolt. Remove headlamp assembly from vehicle.
   

1. Remove park lamp bulb and socket (Sable only) and headlamp bulb and socket from Headlamp Assembly as outlined.
   
   
   Headlamp Assembly (Taurus Shown, Sable Similar)
   
   
   
   

1. Turn lamp socket and wiring (13410) assembly 1/2 turn counterclockwise and remove from parking lamp (13200) housing.
   

1. Remove screw from park/turn signal housing.
   

1. Using 1/4 inch drive socket extension and swivel, insert tool through two access holes in upper radiator support. Remove screws from park/turn signal housing.
   

1. Remove parking lamp from vehicle.
   

1. To install, reverse Removal procedure.
   
   
   Front Lamp-Lamp Assembly, Taurus
   
   
   

This is how to replace the lights on the KitchenAid khlu162m hood. If this is not you hood please give the right make and model # so I can get you the right info.

Replacing the Halogen
lamps:
The hood liner uses 12-volt, 20
watt halogen lamp bulbs.
Before you begin, make sure that
the range hood is turned off and
that the lamps have had sufficient
time to cool.
To replace a halogen lamp:
• Remove 2 screws from the
circular metal trim around the
lamp assembly.
• Pull the trim with the lamp
assembly attached down far
enough so that the lamp can be
pushed out of the socket clips.
• Insert the new lamp into the
socket clips and push the lamp
and trim assembly back up into
the hood.
• Replace the screws.

Good Luck and please rate 4 thumbs up for the free answer.

All you really have to do is go to any store that sells halogen lamps and purchase 2,, 150 watt halogen bulbs. That is what the drum heaters are.
I can send you instructions on how to replace them.
[email protected]
I would suggest, if you can find them. Sylvania halogens rated for 130 volts with vibration protection.
If you cant, thats fine, they just seem to not fail.
But any 150 watt halogen will work.

2005 CHEVROLET Trailblazer
Low beam headlamp
9006
9006SU Silverstar ULTRA for Ultra Night Vision - The Whitest and Brightest Halogen
9006ST Silverstar High Performance Lighting: The Whiter and Brighter Halogen
9006EB EcoBright - Your Environmental Choice
9006XV XtraVision Halogen - The Brighter Light
9006CB Cool Blue Halogen - The Whiter Light

High beam headlamp
9005
9005SU Silverstar ULTRA for Ultra Night Vision - The Whitest and Brightest Halogen
9005ST Silverstar High Performance Lighting: The Whiter and Brighter Halogen
9005EB EcoBright - Your Environmental Choice
9005XV XtraVision Halogen - The Brighter Light
9005CB Cool Blue Halogen - The Whiter Light

Parking light
3757ALL

Front turn signal
3757ALL

Rear turn signal
3157LL

Tail light
3157LL

Stop light
3157LL

High mount stop light
Assembly

Fog/Driving light
880
880ST Silverstar High Performance Lighting: The Whiter and Brighter Halogen
893
893ST Silverstar High Performance Lighting: The Whiter and Brighter Halogen

License plate
2825
2825LL Long Life Upgrade: Up to twice the life of the standard lamp

Back up light
3157LL

Front sidemarker
194
194LL Long Life Upgrade: Up to twice the life of the standard lamp

Glove box
194
194LL Long Life Upgrade: Up to twice the life of the standard lamp

Map light
194
194LL Long Life Upgrade: Up to twice the life of the standard lamp

Dome light
212-2

Step/Courtesy light
194
194LL Long Life Upgrade: Up to twice the life of the standard lamp

Trunk/Cargo area
212-2

A Halogen lamp is a Halogen lamp. They are designed to last between 3000 to 5000 hrs.
You got a much longer life than expected on
the original lamp.

Notes FOG LAMP BULB REPLACEMENT - FRONT

REMOVAL PROCEDURE

1. Remove the front bumper fascia deflector.
2. Disconnect the electrical connector from the front fog lamp bulb/socket. CAUTION: Refer to Halogen Bulb Caution in Service Precautions.

1. Rotate the front fog lamp bulb/socket counterclockwise to release.
2. Remove the fog lamp bulb/socket from the front fog lamp assembly.

1. Install the fog lamp bulb/socket to the fog lamp rotating clockwise until fully seated. CAUTION: Refer to Halogen Bulb Caution in Service Precautions.

1. Connect the electrical connector to the front fog lamp bulb/socket.
2. Install the front bumper fascia deflector.

There are 2 , 150 watt halogen lamps in the drum heater assembly. One or both are burned out.
I can send you instructions on how to replace them. Xerox will want over $250 for an entire heater assembly. You can buy the lamps at Lowes or any place that sells Halogen lamps for around $15 for a set.