What ever programme I put my washing through, the machine fills with soapy water and starts the cycle. However it will not drain the soapy water out in order to rinse the clothes. Instead the dial clicks round continously. If I manually select Drain or Spin it will attempt these actions, fail and the dial will then continue to click round. I've drained the machine by removing the front of the pump on the botttom right hand corner. I did find 10p piece lodged in the waste pipe. The pump appears to be whole and the impellor spins when the machine is on Spin Cycle but the the machine still wont drain. Can anyone help me please?
I have a maytag washer that when it fills with water it wont drain out..the spin cycle just makes a noise and it wont do anything..any ideas what i can do to fix it thanks
Will the water in tub come out when you take off the hose?
I have a ge washer maching and water will not drain will not even go to the thru the spin cycle whats wrong in desperate need.
I have a GE Washer and it fills with water and goes thru the rinse cylce and spin cycle just makes a noise but will not drain the water.
The drain line is probably clogged. Maybe that a sock or other piece of clothing get between the clothes tub and the outer tub that holds the water. In this case it may then get into the drain hose that's attached to the pump.Remove the hoses from the pump and pull the item out. In case it clean there, check the outer tub port- open the washer's main access panel and remove the large-diameter rubber hose that connects the pump to the bottom of the outer tub. Then,try to remove the clothing through the port. Good luck !
Thanks for the advise!
Draining problem is very common in Bosch washers. However, it is very easy to fix. 1)Remove the white circular plate, located on the bottom left. Push a small screwdriver or needle through it and simultaneously rotate the plate clockwise. 2)Open the drain valve. Rotate the circular black handle counterclockwise. Beware of residual water. 3)Clean it. Re-assemble in reverse order. Bosch is an excellent washer. Don't be discouraged by this simple maintenance issue. Serg
I have a whirlpool ultimate care 2 washer,2 yrs old. I went to start it and it did nothing. I reset my circut breaker and it filled up, but will not wash or anything else. I have tried different settings and i tried the circut again. Nothing.
If you have a front loading machine ( I have a GE.), they have a catch sleeve inside the drain line before the drain pump. Remove the lower front panel to access the pump and remove the large hose from the drum. Inside the hose is the sleeve, take out the sleeve and clean it.
Probably a blockage in the drain hose at the back of the machine. Easy to fix. Turn machine off then pull machine out so you can easily access behind. Have bowls and cloths/rags at hand for water spillage. The drain hose is located low down and links into your sink drain, it is held in place by a clip. Remove the clip and hose. This will start to drain the machine so make sure you have enough vessels to catch the water. When the water has stopped draining, check the hose for blockages : buttons / coins / hair grips / paper etc. Also check the hole where the hose attaches to the machine. Remove items then blow through the hose to see if there are any other restrictions. If all clear then replace hose on back of machine. Clear up. Move machine back to normal position. Switch on and set to spin. When complete, the machine should shut off cycle and unlock door. This will save you at least 100 pounds on a call-out. Good luck.
For washing machine draining issue check here:
https://www.samsung.com/in/support/home-appliances/why-is-water-not-draining-properly-from-the-washing-machine/
For SAP training in Chennai visit following link:
http://www.traininginchennai.co.in/sap-training-in-chennai/
Visit this link for any queries regarding washing machine:
https://www.samsung.com/in/support/category/home-appliances/laundry/
Regards, Looking for programming course: https://www.fita.in/java-and-j2ee-training-in-chennai/
Hi I have similar problem, I tried everything and changed water pump thought that the pump was the culprit but still won't work. I tried to reset it and it works! Don't buy water pump unless you're sure that is the problem. Reset it and it will work, here is the link how to reset. http://www.fixya.com/support/t12343001-bosch_maxx_6_reset
Your controller board has a defective triac its a 3 leg 1amp triac
and has a 1k load resistor and a driver transistor that also has a 1k series resistor to the control pin of the triac
its on the controller board
you need to replace the pump back end as its leaking water to the coils and has damaged the driver on the controller board
however its easily repaired
Hi I have a kenmore washer it is not fully draining and on top of that it is starting to leak from the back when it goes into spin cycle. What should I do?
My impeller ingested some coins and other debris that fell out of pockets.
SOURCE: Washing machine will not drain
TAKE THE HOSE OFF ON THE BACK {DISCHARGE HOSE} IF THE WATER FLOWS OUT IT IS THE PUMP MOTOR IF IT DOESN'T THERE IS SOMETHING BLOCKING THE OUTLET, SMALL CLOTHING ITEM
66,479 views
Usually answered in minutes!
My machine runs through the washing cycle but will not drain the water for the rinse cycle to start.
hi! my washer spin but stop when is time to drain and it does nothing else
i removed the hose behind and the remainig of the weter come out. but istill does not work, what should i do???
My washing machine does the same thing. It will do the wash cycle but it won't do the rinse cycle. The dial will continue to turn but the water doesn't drain out. I thought the hose might be clogged. I removed the hose front the top (where it connects into the wall) and blew it in and then ran the rinse cycle. It sounded like it was trying to go through that cycle. It would start and then stop. What should I try next?
The machine will fill and wash but when it is time to drain it makes a noise like the pupm is jammed and it wont drain
Noticed our Whirlpool washing machine cycles where becoming too long and very slow to drain. Would spin for ages before stopping and still clothes seemed soapy. Finally removed the filter from the front access point and found one of the kids socks in it. Once removed all was OK. Should have listened to the wife when she said there was a sock missing weeks before!!
Our Maytag Neptune front loading (older model). will not drain. When the wash cycle is complete the clothes are soaking wet and there is still water left in the bottom of the tub. This has happened on two other occasions. The other two times the problem resolved itself.
My washing machine will not drain
The Drain Pump is not working, i am draining the machine by butting the hose on the floor. All other functions are ok.
they told me it is the PCB and will coast you about 200$, my machine is 15 months old.
thank you
Ok.my Maytag has a similar problem. Will not drain or spin but this only happens in the normal cycle. If i put it to the spin on the other cycles such as gentle it will spin and drain just fine. This tells me it is not plugged and the motor and belt are fine. So what does that leave me? The timer/controller? I have tried to clean it with contact cleaner etc with no luck. Do these go out often? I have replaced every other part on this lousy machine in the 10 years i have owned it. No more Maytags for me.
I replaced a tube that had a whole in it. The
GE washer was running fine until I replaced. I dont know what to do. Now it will not drain or spin. I hear clicks and a hum noise but nothing else.
wash machine will wash but will not drain water out to rinse
Washer machine works but will not drain.
Washing machine will not drain water
will not drain, maytag machine...............how to remove cover to clean drain pipe and or other possiblity
Frigidaire 2 speed Will not spin and drum will not turn.
my washing machine will not drain i just had a new timer put in after 3 weeks of hunting one down as we live in costa Rica, it will use wash cycle but not drain any ideas?
I am currently having the exact same problem but with a different washing machine. It will do the whole wash but when it gets to the end it just stops. I have tried turning it to the fast spin programme but it wont drain the water out. I have taken the drain pipe out thinking something was blocked but when I put it in a bowl on the floor the water all came out. But when I put it in the tap thing again it wont do it because it is raised off the floor. Now all me clothes are soaking wet and I cant get it to spin or drain, I would get it fixed but I am only on benefits and have 2 kids to support. Please can someone offer another alternative, I am desperate and have alot of washing to do now!
Machine does not drain and the water leaks out the bottom onto the floor and soaks the carpet
Kenmore washer will not spin
I HAVE A G E WASHER THATS 1YRS OLD,BUT LIKE MOST AMERICANS I DIDNT BUY THE EXTENTED WARRANTY,G E DOES NOT STAND BY IT PRODUCT,SO IF U BUY G E BE READY TO SPEND ON REPAIRS.THE FRONT LOADER MECHINES ARE NICE BUT THEY WILL ALWAYS HAVE PROBLEM AND THE MANUFRACTURE ARE AWARE OF THIS .SO DO UR SELF A FAVOR AND STAY WITH UR OLD WASHER,THEY LAST FOREVER
I have a KitchenAid washer. I loaded the machine and put the program on Normal cylce. The machine works for a few minutes and stops. I pressed the program knob to switch off and again pull it out to restart. Upon doing that the machine starts draining and stops after a while. This draining and stopping continues by itself. If I advance the programe manually, the agitation action does not take place nor does spin action take place. Could you pls suggest a solution? Thanks
hey cricket change the pamp
??????????????????????????????
×