My printer was working fine, and suddenly no longer works and states FATAL ERROR CODE: 0300H. Can you advise what this means and what I can do about it. I have turned off and on, checked for paper jams, checked cartridges in okay. At first the printer made a noise when I turned it back on, now nothing happens at all.
Thank you.
SOURCE: Konica Magicolor 5430 DL Fatal Error Code: 0300H
0300H: Polygon Motor malfunction
try restart if not helping then there can be problem with ph unit or PWB-A board
SOURCE: HP8250 printer
Try this: Remove both ink cartridges. Unplug the printer for a few minutes. Plug it back in and re-install the cartridges.
SOURCE: Printer states System Error Clear paper jam but no paper is there
If you did have a jam and did not get ALL the jammed sheet out, there is still a small piece of paper in there somewhere, probably covering a sensor or micro switch. Get a torch and look carefully. If youu don't find anything you may need to disassemble the printer to find it.
SOURCE: says a front paper jam but no paper jammed any where
Your paper feder belt has ink on it and will not feed the paper. Remove the rubber belt and clean it good and clean and use compressed air on the printer tray area. If this does not work open the front feeder tray and set your computer to print from it. After about 500 copys it will normally have c leaned itself and be ready to feed from the main roller.
104 views
Usually answered in minutes!
When I turn on the printer, it starts to make a high pitch whining noise then stops and has an error code 0300H.
×